Loading ...
Loading ...
Loading ...
sors. A warning lamp lights up in the exterior
mirrors and draws your attention to vehicles
detected in the monitored area. If you then
switch on the corresponding turn signal to
change lanes, you will also receive a visual warn-
ing and a warning tone.
Blind Spot Assist supports you from a speed of
approximately 20 mph (30 km/h).
Important safety notes
G
WARNING
Blind Spot Assist does not react to:
R
vehicles overtaken too closely on the side,
placing them in the blind spot area
R
vehicles which approach with a large speed
differential and overtake your vehicle
As a result, Blind Spot Assist may not give
warnings in such situations. There is a risk of
an accident.
Always observe the traffic conditions care-
fully, and maintain a safe lateral distance.
Blind Spot Assist is only an aid. It may fail to
detect some vehicles and is no substitute for
attentive driving. Always ensure that there is
sufficient distance to the side for other road
users and obstacles.
i
USA only:
This device has been approved by the FCC as
a "Vehicular Radar System". The radar sensor
is intended for use in an automotive radar
system only. Removing, tampering with, or
altering the device will void any warranties,
and is not permitted by the FCC. Do not tam-
per with, alter, or use in any non-approved
way.
Any unauthorized modification to this device
could void the user's authority to operate the
equipment.
Radar sensors
The radar sensors for Blind Spot Assist are inte-
grated into the rear bumper. Make sure that the
bumpers are free from dirt, ice or slush. The
sensors must not be covered, for example by
cycle racks or overhanging loads. Following a
severe impact or in the event of damage to the
bumpers, have the function of the radar sensors
checked at a qualified specialist workshop.
Blind Spot Assist may no longer work properly.
Monitoring area
In particular, the detection of obstacles can be
impaired if:
R
There is dirt on the sensors or anything else
covering the sensors
R
there is poor visibility, e.g. due to fog, heavy
rain, snow or spray
R
there are narrow vehicles, e.g. motorcycles or
bicycles
R
the road has very wide lanes
R
the road has narrow lanes
R
you are not driving in the middle of the lane
R
there are barriers or other road boundaries
Vehicles in the monitoring range are then not
indicated.
At a distance of around 1.6 ft (0.5 m) ; from the
vehicle, Blind Spot Assist monitors the area up
to 10 ft (3 m) next to = and behind : your
vehicle, as shown in the picture.
If the lanes are narrow, vehicles driving in the
lane beyond the lane next to your vehicle may be
indicated, especially if the vehicles are not driv-
ing in the middle of their lane. This may be the
case if the vehicles are driving on the inner side
of their lane.
Due to the nature of the system:
R
warnings may be issued in error when driving
close to crash barriers or similar solid lane
borders
R
warnings may be interrupted when driving
alongside long vehicles, e.g. trucks, for a pro-
longed time
194
Driving systems
Driving and parking
Loading ...
Loading ...
Loading ...