Loading ...
Loading ...
Loading ...
More information on HomeLink
®
and/or com-
patible products is also available online at
http://www.homelink.com.
Notes on the declaration of conformity
(Y page 278).
USA: FCC ID: CB2HMIHL4
Canada: IC: 279B-HMIHL4
Important safety notes
G
WARNING
When you operate or program the door with
the integrated garage door opener, persons in
the range of movement of the door may
become trapped or be struck by the door.
There is a risk of injury.
When using the integrated garage door
opener, always make sure that nobody is
within the range of movement of the door.
G
DANGER
Combustion engines emit poisonous exhaust
gases such as carbon monoxide. Inhaling
these exhaust gases is hazardous to health
and can result in poisoning. There is a risk of
fatal injury. Therefore, never leave the engine
running an enclosed space without adequate
ventilation.
Programming
Programming buttons
Pay attention to the "Important safety notes"
(Y page 296).
Garage door remote control A is not included
with the integrated garage door opener.
X
Turn the SmartKey to position 2 in the igni-
tion lock (Y page 131).
X
Select one of buttons ; to ? to use to con-
trol the garage door drive.
X
To start programming mode: press and
hold one of buttons ; to ? on the integrated
garage door opener.
The garage door opener is in programming
mode. After a short time, indicator lamp :
lights up yellow.
Indicator lamp : lights up yellow as soon as
button ;, = or ? is stored for the first time.
If the selected button has already been pro-
grammed, indicator lamp : will only light up
yellow after ten seconds have elapsed.
X
Release button ;, = or ?. Indicator
lamp : flashes yellow.
X
To program the remote control: point
garage door remote control A towards but-
tons ; to ? on the rear-view mirror at a dis-
tance of 2 to 8 in (5 to 20 cm).
X
Press and hold button B on remote control
A until indicator lamp : lights up green.
When indicator lamp : lights up green: pro-
gramming is finished.
When indicator lamp : flashes green: pro-
gramming was successful. The rolling code
must be synchronized (Y page 296).
X
Release button B on remote control A for
the garage door drive system.
If indicator lamp : lights up red: repeat the
programing procedure for the corresponding
button on the rear-view mirror. When doing
so, vary the distance between remote control
A and the rear-view mirror.
The required distance between remote con-
trol A and the integrated garage door opener
depends on the garage door drive system.
Several attempts might be necessary. You
should test every position for at least
25 seconds before trying another position.
Synchronizing the rolling code
Pay attention to the "Important safety notes"
(Y page 296).
If the garage door system uses a rolling code,
you will also have to synchronize the garage
door system with the integrated garage door
opener in the rear-view mirror. To do this you will
need to use the programming button on the door
drive control panel. The programming button
may be located in different places depending on
296
Features
Stowage and features
Loading ...
Loading ...
Loading ...