Loading ...
Loading ...
Loading ...
3-7
INSP
ADJ
E
CONTROL SYSTEM/FUEL SYSTEM
3. Adjust:
● YPVS cables 1 and 2
FUEL SYSTEM
WARNING
● Stop the engine, set the fuel cock to
“OFF” before servicing the fuel system.
● When removing fuel system parts, wrap
them in a cloth and take care that no fuel
spills into the engine compartment.
Fuel line inspection
1. Inspect:
● Fuel filter 1
Contaminants → Replace.
Cracks/damage → Replace.
Water contamination → Replace and
check the fuel tank.
● Fuel hoses
● Fuel tank
● Fuel hoses through part
● Fuel filler cap
Cracks/damage → Replace.
Adjustment steps:
● Loosen locknuts 1 and 2.
● Turn in adjusters 3 and 4 until there
is slack in the cables.
● Align the hole a in the pulley with the
hole in the cylinder.
● Insert a 4-mm-diameter pin through
the holes in the pulley and cylinder.
● Turn adjusters 3 and 4 in or out until
the specified slack is obtained.
Turn in Slack is increased.
Turn out Slack is decreased.
● Finger tighten locknuts 1 and 2.
● Remove the pin.
● Start and stop the engine.
● Recheck the hole alignment.
● If the hole alignment is correctly,
tighten the locknuts.
● If the hole alignment is incorrect,
repeat the above steps.
41
3
2
Loading ...
Loading ...
Loading ...