Loading ...
Loading ...
Loading ...
16
·
Dynamic
If you choose Dynamic as the IP address mode, make sure that there is a reachable
DHCP server on your network and the DHCP sever is properly configured to assign IP
address and the other network parameters to the EAP.
For network stability, you can also configure the fallback IP parameters for the EAP:
Fallback IP With the fallback IP configured, if the EAP fails to get an IP address from a
DHCP server within 10 seconds, the fallback IP will work as the IP address
of the EAP. After that, however, the EAP will keep trying to obtain an IP
address from the DHCP server until it succeeds.
DHCP Fallback
IP
Specify a fallback IP address for the EAP. Make sure that this IP address
is not being used by any other device in the same LAN.
DHCP Fallback
IP MASK
Specify the network mask of the fallback IP.
DHCP Fallback
Gateway
Specify the network gateway.
·
Static
If you choose Static as the IP address mode, you need to manually specify an IP
address and the related network parameters for the EAP. Make sure that the specified
IP address is not being used by any other device in the same LAN.
Configure the IP address and network parameters as the following table shows:
IP Address Specify a static IP address for the EAP.
Loading ...
Loading ...
Loading ...