Loading ...
Loading ...
Loading ...
Changing the speed
Press the rocker switch up or down repeatedly
until the desired speed is set.
If active, the displayed speed is stored and the
vehicle reaches the stored speed when the
road is clear.
▷ Each time the rocker switch is pressed to
the resistance point, the desired speed in‐
creases or decreases by 1 mph/1 km/h.
▷ Each time the rocker switch is pressed
past the resistance point, the desired
speed changes by a maximum of 5 mph/
10 km/h.
Hold the rocker switch in position to repeat the
action.
Adjusting distance
Safety information
WARNING
The system does not relieve from per‐
sonal responsibility. Due to the system limits,
braking can be late. There is a risk of accidents
or risk of damage to property. Be aware to the
traffic situation at all times. Adjust the distance
to the traffic and weather conditions and main‐
tain the prescribed safety distance, possibly by
braking.◀
Without steering and lane control
assistant: reducing distance
Press button repeatedly until the de‐
sired distance is set.
Instrument cluster will display selected dis‐
tance, refer to page 199.
Without steering and lane control
assistant: increasing distance
Press button repeatedly until the de‐
sired distance is set.
Instrument cluster will display selected dis‐
tance, refer to page 199.
With steering and lane control
assistant: adjusting distance
Press button repeatedly until the de‐
sired distance is set.
Continuing cruise control
An interrupted cruise control can be continued
by calling up the stored speed.
Make sure that the difference between current
speed and stored speed is not too large before
calling up the stored speed. Otherwise, unin‐
tentional braking or accelerating may occur.
Press button with the system inter‐
rupted.
Cruise control is continued with the saved val‐
ues.
In the following cases, the stored speed value
is deleted and cannot be called up again:
▷ When the system is switched off.
▷ When drive-ready state is switched off.
Displays in the instrument cluster
Display in the speedometer
▷ Green marking: system is
active, the marking indicates
the desired speed.
▷ Orange/white marking: sys‐
tem is interrupted, the mark‐
ing indicates the stored
speed.
Seite 198
Controls Driver assistance systems
198
Online Edition for Part no. 01402981865 - VI/17
Loading ...
Loading ...
Loading ...