Loading ...
Loading ...
Loading ...
(377,1)
北米Model "A1700BE-B" EDITED: 2017/ 10/ 11
! Before starting the engine
Before using the remote engine start
system to start the engine, confirm the
following conditions.
. The select lever is in the “P” position.
. All doors are closed.
. The engine hood is closed.
. The push-button ignition switch is in the
“OFF” position.
! Starting the engine
1. Press the lock button briefly. The
hazard warning flashers then flash once.
2. Within 2 seconds, press the lock button
briefly again. The hazard warning flashers
then flash once again.
3. After step 2, immediately press and
hold the lock button. The hazard warning
flashers then flash once.
4. Approximately 3 seconds after step 3,
release the lock button. The engine will
then start successfully.
! Stopping the engine
Press and hold the lock button to stop the
engine with remote engine start system.
! Automatic engine shutdown
The remote engine start system will auto-
matically shut down or will not start the
engine under the following conditions.
. The total run-time has exceeded 20
minutes.
. Any door is opened.
. The select lever is moved to any
position other than “P”.
. The engine hood is opened.
. The push-button ignition switch is
pressed.
. The brake pedal is depressed.
. The engine speed is 3,000 rpm or more.
The time setting until the engine automa-
tically stops can be changed. To change it,
please contact your SUBARU dealer. Note
that some settings may vi olate st ate,
provincial, or local laws and regulations.
Check the laws in your area to determine
which setting is permitted.
! Entering the vehicle while it is run-
ning via remote start
1. Unlock the vehicle doors using the
keyless access function. If you unlock the
vehicle’s doors manually using the key, the
vehicle’s alarm system will trigger (if the
alarm system is armed prior to activating
the remote engine start system) and the
engine will turn off. Perform either of the
following procedures to disarm the alarm
system. Refer to “Alarm system” F2-24.
. Switch the ignition to the “ACC” or
“ON” state by pressing the push-button
ignition switch once or twice, respec-
tively.
. Press any button on the access key
fob/transmitter.
2. Enter the vehicle.
3. The engine will shut down when any
door is opened.
4. Press the push-button ignition switch
while depressing the brake pedal to restart
the engine.
! Entering the vehicle following re-
mote engine start shutdown
An alarm trigger may occur if the vehicle is
opened by t he remote keyl ess entry
transmitter within a few seconds immedi-
ately following remote engine start shut-
down.
! Pre-heating or pre-cooling the in-
terior of the vehicle
Before exiting the vehicle, set the tem-
perature controls to the desired setting and
operation. After the system starts the
engine, the heater or air conditioning will
activate and heat or cool the interior to
your setting.
– CONTINUED –
Starting and operating/Starting and stopping the engine
7-15
7
Loading ...
Loading ...
Loading ...