Loading ...
Loading ...
Loading ...
STARTING AND OPERATING 179
NOTE:
Remember, never drive diagonally across a hill
- drive straight up or down.
If the wheels start to slip as you approach the
crest of a hill, ease off the accelerator and
maintain headway by turning the front wheels
slowly left and right. This may provide a fresh
“bite” into the surface and may provide traction
to complete the climb.
Traction Downhill
Shift the transmission into a low gear and the
4WD System to 4WD LOW range or Select Hill
Descent Control if equipped Ú page 263. Let
the vehicle go slowly down the hill with all four
wheels turning against engine compression
drag. This will permit you to control the vehicle
speed and direction.
When descending mountains or hills, repeated
braking can cause brake fade with loss of
braking control. Avoid repeated heavy braking
by downshifting the transmission whenever
possible.
After Driving Off-Road
Off-road operation puts more stress on your
vehicle than does most on-road driving. After
going off-road, it is always a good idea to check
for damage.
Completely inspect the underbody of your
vehicle. Check tires, body structure, steering,
suspension, and exhaust system for damage.
Inspect the radiator for mud and debris and
clean as required.
Check threaded fasteners for looseness,
particularly on the chassis, drivetrain compo-
nents, steering, and suspension. Retighten
them, if required, and torque to the values
specified in the Service Manual.
Check for accumulations of plants or brush.
These things could be a fire hazard. They
might hide damage to fuel lines, brake hoses,
axle pinion seals, and propeller shafts.
After extended operation in mud, sand,
water, or similar dirty conditions, have the
radiator, fan, brake rotors, wheels, brake
linings, and axle yokes inspected and
cleaned as soon as possible.
Impacted material can cause wheel imbal-
ance. Freeing the wheels of impacted mate-
rial will likely rectify imbalance condition.
WARNING!
Abrasive material in any part of the braking
system may cause excessive wear or
unpredictable braking performance. Full
braking power may not be available to prevent
a collision. If you have been operating your
vehicle in dirty conditions, inspect and clean
the braking components as soon as possible.
4
21_KL_OM_EN_USC_t.book Page 179
Loading ...
Loading ...
Loading ...