Loading ...
Loading ...
Loading ...
176 STARTING AND OPERATING
The ignition must be in the ON/RUN mode for
a shift to take place and for the position indi-
cator lights to be operable. If the ignition is
not in the ON/RUN mode, the shift will not
take place and no position indicator lights will
be on or flashing.
A flashing NEUTRAL (N) position indicator
light indicates that shift requirements have
not been met.
Shifting Out Of NEUTRAL (N)
Use the following procedure to prepare your
vehicle for normal usage.
1. Bring the vehicle to a complete stop,
leaving it connected to the tow vehicle.
2. Apply the parking brake.
3. Turn the ignition to the ON/RUN mode, but
do not start the engine.
4. Press and hold the brake pedal.
5. Shift the transmission into NEUTRAL.
6. Using a ballpoint pen or similar object, push
and hold the recessed power transfer unit
NEUTRAL (N) button (located by the selector
switch) for one second.
Neutral Button
7. When the NEUTRAL (N) indicator light turns
off, release the NEUTRAL (N) button.
8. After the NEUTRAL (N) button has been
released, the power transfer unit will shift to
the position indicated by the selector switch.
NOTE:
When shifting the power transfer unit out of
NEUTRAL (N), the engine should remain off to
avoid gear clash.
9. Shift the transmission into PARK.
10. Release the brake pedal.
11. Disconnect vehicle from the tow vehicle.
12. Start the engine.
13. Press and hold the brake pedal.
14. Release the parking brake.
15. Shift the transmission into DRIVE, release
the brake pedal, and check that the vehicle
operates normally.
16. Re-enable the Auto Park Brake feature, if
desired.
NOTE:
Steps 1 through 5 are requirements that
must be met before pushing the NEUTRAL (N)
button, and must continue to be met until the
shift has been completed. If any of these
requirements are not met before pushing the
NEUTRAL (N) button or are no longer met
during the shift, the NEUTRAL (N) indicator
light will flash continuously until all require-
ments are met or until the NEUTRAL (N)
button is released.
The ignition must be in the ON/RUN mode for
a shift to take place and for the position indi-
cator lights to be operable. If the ignition is
not in the ON/RUN mode, the shift will not
take place and no position indicator lights will
be on or flashing.
21_KL_OM_EN_USC_t.book Page 176
Loading ...
Loading ...
Loading ...