Loading ...
Loading ...
Loading ...
160 STARTING AND OPERATING
PARKVIEW REAR BACK UP CAMERA
Your vehicle is equipped with the ParkView Rear
Back Up Camera that allows you to see an on-screen
image of the rear surroundings of your vehicle
whenever the gear selector is put into REVERSE.
The image will be displayed in the touchscreen
display along with a caution note to “check entire
surroundings” across the top of the screen. After
five seconds this note will disappear. The ParkView
camera is located on the rear of the vehicle above
the rear license plate.
NOTE:
The ParkView Rear Back Up Camera has
programmable modes of operation that may
be selected through the Uconnect system
Ú page 181.
When the vehicle is shifted out of REVERSE
(with camera delay turned off), the rear camera
mode is exited and the previous screen
appears. When the vehicle is shifted out of
REVERSE (with camera delay turned on), the
camera image will continue to be displayed
for up to 10 seconds unless the following
conditions occur: the vehicle speed exceeds
8 mph (13 km/h), the vehicle is shifted into
PARK, the vehicle’s ignition is placed in the OFF
position, or the touchscreen button “X” to
disable the display of the Rear View Camera is
pressed.
Manual Activation Of The Rear View Camera
1. Press the “Controls” button located on the
bottom of the Uconnect display.
2. Press the “Backup Camera” button to turn
the Rear View Camera system on.
NOTE:
If the Rear View Camera was manually acti-
vated, the timer will start again only after the
vehicle speed exceeds 8 mph (13 km/h).
NOTE:
If the vehicle speed remains below 8 mph
(13 km/h), the Rear View Camera image will
be displayed continuously until deactivated
via the touchscreen button “X”, the vehicle is
shifted into PARK, or the ignition is placed in
the OFF position.
The touchscreen button “X” to disable display
of the camera image is made available ONLY
when the vehicle is not in REVERSE.
When enabled, active guidelines are overlaid on
the image to illustrate the width of the vehicle
and its projected backup path based on the
steering wheel position. A dashed center line
overlay indicates the center of the vehicle to
assist with parking or aligning to a hitch/
receiver.
Different colored zones indicate the distance to
the rear of the vehicle.
The following table shows the approximate
distances for each zone:
Zone
Distance To The Rear Of The
Vehicle
Red 0 - 1 ft (0 - 30 cm)
Yellow 1 ft - 6.5 ft (30 cm - 2 m)
Green
6.5 ft or greater
(2 m or greater)
21_KL_OM_EN_USC_t.book Page 160
Loading ...
Loading ...
Loading ...