Loading ...
Loading ...
Loading ...
248 IN CASE OF EMERGENCY
JACKING AND TIRE CHANGING
Jack Location/Spare Tire Stowage
If equipped, the jack and tools are located in the
rear storage compartment, below the spare tire.
NOTE:
Items may vary depending on the trim level.
Jack And Tools Location
1. Open the liftgate.
2. Lift the access cover using the load floor
handle.
Load Floor Handle
3. Remove the fastener securing the spare
tire, and remove the spare wheel from the
vehicle. The jack will be found beneath.
Spare Tire Fastener
4. Remove the alignment pin from the middle,
rotate the jack counterclockwise, and lift it
from the foam tray.
WARNING!
Do not attempt to change a tire on the side
of the vehicle close to moving traffic. Pull
far enough off the road to avoid the danger
of being hit when operating the jack or
changing the wheel.
Being under a jacked-up vehicle is
dangerous. The vehicle could slip off the
jack and fall on you. You could be crushed.
Never put any part of your body under a
vehicle that is on a jack. If you need to get
under a raised vehicle, take it to a service
center where it can be raised on a lift.
Never start or run the engine while the
vehicle is on a jack.
The jack is designed to be used as a tool for
changing tires only. The jack should not be
used to lift the vehicle for service purposes.
The vehicle should be jacked on a firm level
surface only. Avoid ice or slippery areas.
1 — Jack
2 — Alignment Pin
3 — Wheel Bolt Wrench
4 — Emergency Funnel
5 — Screwdriver
20_MP_OM_EN_USC_t.book Page 248
Loading ...
Loading ...
Loading ...