Loading ...
Loading ...
Loading ...
M710 User Manual 10
Setup
Printer Settings
Important! If you change the printer name after using the printer with the Brady Express
Labels mobile app (see “Software for Creating Labels” on page 12), additional steps are
needed to update the printer name in the software.
• Reboot the printer. (Turn the printer off and then on again.)
• In the Brady Express Labels app, go to settings and add the printer again.
•
Shut Off Delay:
Set the amount of time, in minutes, that the printer should remain idle before
shutting down automatically.
•
No Shut Off (AC):
Select this check box to turn off the automatic shutdown, which is not
needed when the printer is plugged in.
•
Brightness:
Change the brightness of the touchscreen.
•
Clean Printer:
For more information see
“Cleaning the Printer” on page 87
.
•
No Backfeed:
Applies only to continuous label supplies. After a label has been printed and cut
on a continuous label supply, about 1.5" (38.1 mm) of label material remains ahead of the
printhead, in a position where it would not be printed on. In order not to waste this label material,
the printer normally backfeeds (retracts) the label supply before printing. If the label supply has
been in the printer for awhile, the roller can leave an indentation on the label supply. When
retracted into the printer for printing, the print quality can be bad on the indentation. To resolve
this issue, select the
No Backfeed
check box. Printing starts at the current position leaving
about 1.5" (38.1 mm) of blank label at the leading edge.
Tip: If printing many labels you may want to avoid the excess blank area at the beginning
of each label. Clear the No Backfeed check box. If the first label is unsatisfactory,
reprint just the first label. To print a range of labels (from 1 to 1), see “Multiple Print”
on page 36.
•
About:
Displays version numbers for firmware, Bluetooth, Wi-Fi, and the Printer Label Library.
See
“Installing Firmware Upgrades” on page 85
and
“Updating the Printer Label Library” on
page 86
.
5. Tap OK.
6. Press to dismiss the menu. Alternatively, use the navigation keys to navigate to the
next setting that you want to configure.
Print History
Choose whether you want the printer to retain a history of recently used files.
To configure print history:
1. Press FN + SETUP.
2. Use the navigation keys to move through the menu until Print History is highlighted.
3. Use the up and down navigation keys to select the desired function.
•
On:
The printer retains a history of the last ten label files used.
•
Off:
Print history is no longer retained, but any existing history remains.
•
Clear:
Delete the history. This does not affect the on or off setting.
4. Press to accept the choice.
Loading ...
Loading ...
Loading ...