Hikvision DS-K3B411BX User Manual

Loading ...

Note

●

The power cable from power supply to the main lane control board has been connected. You will

need to prepare the 14AWG power cable to connect the AC power input to power supply.

●

The supplied 2 interconnecng cables need connecng on-site:

1. 24 V power cable of 14 AWG. The cable is 4 m in length and put inside the right/middle

pedestal at the exit.

2. CAT5e

Communicaon cable. The cable is 3.75 m in length and put inside the package of the

right/middle pedestal.

●

The ① and ② or ③ and ④ refer to the two sides of a same board.

●

Barrier opens at the entrance/exit: connect to BTN1/BTN2 and GND.

4.3.8 RS-485 Wiring

The RS-485 interfaces on the access control board and sub extended interface board are suggested

to connect with the face

recognion module or the card reader. Here takes connecng with a card

reader as an example.

Note

●

There are 2 RS-485 interfaces on the access control board for entrance. Refer to Access Control

Board Terminal Descripon (Oponal) for details.

There are 2 RS-485 interfaces on the sub extended interface board for exit. Refer to Sub

Extended Interface Board Terminal Descripon for details.

●

connecng the RS-485 with a card reader, by default, the DIP switch of the card reader should

be set as follows:

○

For entrance, set the No.1 of the 4-digit DIP switch to ON side.

○

For exit, set the No.3 of the 4-digit DIP switch to ON side.

●

If there are other RS-485 devices

connecng, the ID of the RS-485 cannot be conicted.

●

The connected 12 V power interface for the face

recognion terminal cannot be connected with

other 12 V devices.

Figure 4-10 Wiring RS-485

DS-K3B411B(L)X Series Swing Barrier User Manual

Loading ...

Hikvision DS-K3B411BX Value Swing Barriers