Loading ...
Loading ...
Loading ...
4.
Click OK.
5.
Oponal: Set the switch on the upper right corner to ON to trigger the alarm output.
Congure Parameters for Lane Controller
Aer adding the lane controller to the client, you can congure its parameters for passing through
the lane.
Steps
1.
Click Access Control → Advanced
Funcon → Device Parameter to enter Parameter Sengs
page.
2.
In the device list on the le, select a lane controller and you can edit the lane controller's
parameters on the right.
3.
Edit the parameters.
Passing Mode
Select the controller which will control the barrier status of the device.
Note
You can select either According to Device's Passing Mode or According to Door's Schedule
Sengs.
●
If you select According to Device's Passing Mode, the device will follow the lane
controller's passing mode, which can be
congured in remote control sengs page, to
control the barrier.
●
If you select According to Door's Schedule
Sengs, the device will follow the sengs of
the soware to control the barrier.
Free Passing Authencaon
If you enable this funcon, when both entrance and exit's barrier mode is Remain Open, the
pedestrians should
authencate each me passing through the lane. Or an alarm will be
triggered.
Opening/Closing Door Speed
Set the barrier's opening and closing speed. You can select from 1 to 10. The greater the
value, the faster the speed.
Note
The recommended value is 6.
Audible Prompt Duraon
Set how long the audio will last, which is played when an alarm is triggered .
Note
0 refers to the alarm audio will be played unl the alarm is ended.
DS-K3B411B(L)X Series Swing Barrier User Manual
89
Loading ...
Loading ...
Loading ...