Loading ...
Loading ...
Loading ...
Portable Calibration Baths
Calibrate the Product
67
10. Once the tank is empty, insert the drain plug and tighten it securely.
11. Replace the drain cover.
12. Use a paper towel or other clean absorbent material to remove any fluid that
remains in the tank.
13. Clean up any drips or spills.
14. Dispose of the bath fluid in a legal and environmentally-friendly manner.
Check the bath fluid disposal information.
Transport the Calibration Bath
To prepare the Product for transport:
1. Set the setpoint to 25 °C and wait for the Product to heat or cool to between
5 °C and 60 °C.
2. Turn off the Product and disconnect the mains power cord.
3. Remove all accessories.
4. Drain the fluid as explained in Drain the Bath Fluid.
5. Place the transport cover over the tank and fasten it securely.
6. Install the overflow plug on the overflow tube.
7. Wipe off any fluid on the Product.
8. Use the carrying handle and the recessed handle on the side to lift the
Product.
9. If you transport the Product by car or truck, carefully pack the Product in the
original shipping carton.
10. Follow the instructions provided in Setup to prepare the Product for operation
at the new location. Remember to remove the overflow plug when the
overflow kit is used.
Calibrate the Product
This section provides instructions to calibrate and adjust the Product to ensure it
meets performance specifications. During Calibration:
• The environment temperature should be steady between 19 °C and 27 °C.
• Avoid air drafts.
• Use the recommended silicone fluid.
• Check that the tank is filled between the MIN and MAX levels.
• Use the provided probe access cover.
1.888.610.7664 sales@GlobalTestSupply.com
Fluke-Direct.com
Loading ...
Loading ...
Loading ...