Loading ...
Loading ...
Loading ...
6109A/7109A
Operators Manual
10
Control Panel
The control panel is shown in Figure 3.
F1 F2 F3 F4
BACK
PROGRAM
SETPOINT
1 3
46
2
5
798
0
.
STOP
SELECT
ENTER
MONITOR
SETUP
PORTABLE CALIBRATION BATH
6109A
35°C TO 250°C
1
2
3
5
6
4
icu05.eps
Number Description
Display - Shows the information about the operation of the Product such as the fluid
temperature and setpoint.
Softkeys - These keys correspond to the display icons directly above each key. The
functions change with the status of the display. In many menus is labeled Done.
It returns the screen to the first menu.
As you type numbers for settings, acts as a backspace key. This deletes the last
digit in the number. If a setting accepts a number in exponential notation, works
as an exponent key.
Mode Keys - , , , and access different groups of settings. Some
mode keys light up when the mode is active.
Other Keys - Controls used to operate the Product. There are numbers, cursor keys,
and to make menu choices.
- Returns the UI to the prior menu.
and - Use to move the cursor up or down.
and - Use to move the cursor left or right.
Number keys (0-9) - Use the ten number keys to enter decimal numbers. If a setting
accepts an exponential number, a special exponent key is shown as one of the softkeys.
Push to save the number.
- Change a selected item. After the setting is changed, push to save the new
value. Settings that have only binary states, such as ON or OFF, are changed and
saved with a single push.
Hot Warning Indicator - This indicator lights up if the fluid temperature is ≥60 °C. This
warns that the bath fluid, tank cover, and area around the tank are hot and should not
be touched. If the Product is switched off, the indicator stays on until the Product
reaches a safe temperature. It flashes at a slow rate to conserve energy.
- Immediately disables heating and cooling and switches off the stir motor.
Figure 3. Control Panel
1.888.610.7664 sales@GlobalTestSupply.com
Fluke-Direct.com
Loading ...
Loading ...
Loading ...