Loading ...
Loading ...
Loading ...
Portable Calibration Baths
Menu Guide
37
• Temperature Resolution selects the number of decimal places in
temperatures shown on the display.
• Display Brightness sets the brightness of the backlight, which may need
to be adjusted depending on ambient light.
• Screen Saver causes the display to turn off after a period of time without
operator actions. Push any key to turn the display on again. The Product
continues to operate and control temperature while the display is dark.
• Key Beep controls whether the Product beeps each time a key is pushed.
• Stability Beep controls whether the Product beeps when the ready
indicator turns green. This setting is also located in the Setup Operation
menu.
(Setup > Instrument > More) Control
Change temperature control parameters.
Depending on the fluid used, the Product may achieve slightly better
temperature stability after fine-tuning the control parameters. This should
only be done by a knowledgeable technician when necessary. Incorrect
values could cause the bath temperature to oscillate or drift.
The password is required to change these settings.
• Stir Speed sets the speed of the stir motor. The normal speed is 2000
revolutions per minute (RPM). When bath fluids are used that have low
viscosity, the operator might want to decrease the stir speed to reduce
spatter.
Note
The stir motor only runs when temperature control is enabled.
• Proportional Band controls the gain of the control function. A larger value
decreases gain and a smaller proportional band increases gain.
• Integral Time controls the settling time of the control function.
• Derivative Time controls stability compensation.
(Setup > Instrument > More > Control) Default
Change the control parameters back to factory default values.
(Setup > Instrument > More) Password
Change the security settings.
The password is required to access this menu. The default password is
1234.
The password is the security code required by any protected menu,
including this one.
IMPORTANT: Do not lose your password. If you do lose your
password, contact Fluke Calibration.
1.888.610.7664 sales@GlobalTestSupply.com
Fluke-Direct.com
Loading ...
Loading ...
Loading ...