Loading ...
Loading ...
Loading ...
Optera™ Operations Manual
C2284M | 08/20
18
1. Go to Network & Security > Traffic Shaping.
1. Enable Traffic Shaping with or without bursts, depending on your need.
l Disabled: Camera will send data at full network hardware link speed (For example: 100 Mbps
or 1 Gbps).
l Enabled: Camera will limit the rate at which it sends data. In this setting, the “averaging period”
(the period over which the rate limit is valid) is 1 ms. The rate limit for this setting is 12.5 Mbps <
R < 100 Mbps.
l Enabled with Bursts: This advanced setting allows you to specify the maximum burst size
that the camera can send at the hardware link speed. This balances video latency with the
transmission rate.
2. Set the average transmission rate over a 2 ms period in Mbps when enabled with bursts.
3. If you enabled traffic shaping with bursts, set the maximum size of bursts coming from the camera
in kilobytes.
4. Click Save.
Configuring 802.1x Security
By default, 802.1x security is off. Cameras support EAP-MD5, EAP-TLS, EAP-TTLS, EAP-PEAP, and
EAP-FAST protocols.
1. Go to Network & Security > 802.1x.
2. Select On for 802.1x port security.
3. Select the (EAP) method from the Protocol drop-down menu.
4. Provide the authentication information for the EAP method you selected.
5. Click Save.
Configuring SNMP
Your camera supports No SNMP, SNMP V2c, and V3, and it can be configured to send traps. The MIB file
for your camera is available at www.pelco.com.
Note: SNMP V2c and SNMP V3 configuration settings are independent of each other, but only one
SNMP mode can be active.
Loading ...
Loading ...
Loading ...