Loading ...
Loading ...
Loading ...
SIGLENT
102 SDS2000X User Manual
LIN Triggering
LIN triggering can trigger on the rising edge at the Sync Break exit of the LIN single-wire
bus signal (that marks the beginning of the message frame), the Frame ID, or the Frame
ID and Data.
A LIN signal message frame is shown below:
1. Press Setup to enter trigger function menu.
2. Press the Type softkey; then, turn the Universal Knob to select the ―serial‖ and press
the Protocol softkey to select ―LIN‖.
3. Press the Trigger Setting softkey to enter the LIN TRIG SET menu.
4. Press the Trigger Setting softkey; then, turn the Universal Knob to select the trigger
condition:
Start — The oscilloscope triggers when a start bit occurs
ID (Frame ID) — The oscilloscope triggers when a frame with an ID equal to the
selected value is detected. Use the Universal Knob to select the value for the
Frame ID.
ID + Data (Frame ID and Data) — The oscilloscope triggers when a frame with an
ID and data equal to the selected values is detected. Use the Universal Knob to
select the value for the ID, Data1 and Data2.
Data Error —The oscilloscope triggers when detects data error.
Figure 58 LIN Trigger
Loading ...
Loading ...
Loading ...