Loading ...
Loading ...
Loading ...
SIGLENT
SDS2000X User Manual 97
CAN Triggering
After setting up the oscilloscope to capture a CAN signal:
1. Press Setup button the front panel to enter the TRIGGER function menu.
2. Press the Type softkey; then, turn the Universal Knob to select the ―serial‖ and press
the Protocol softkey to select ―CAN‖.
3. Press the Trigger Setting softkey to enter the CAN TRIG SET menu.
4. Press the Trigger softkey; then, turn the Universal Knob to select the trigger
condition:
Start— The oscilloscope triggers at the start of a frame.
Remote — The oscilloscope triggers on remote frames with the specified ID.
a. Press the ID Bits softkey to select the ID number 11bits or 29 bits.
b. Press the Curr ID Byte softkey and turn the universal to select the byte to be set.
c. Press the ID softkey and then turn the universal to set the ID
ID — The oscilloscope will trigger on remote or data frames matching the
specified ID
a. Press the ID Bits softkey to select the ID number 11bits or 29 bits.
b. Press the Curr ID Byte softkey and turn the universal to select the byte to be set.
c. Press the ID softkey and then turn the universal to set the ID
ID+DATA—The oscilloscope will trigger on data frames matching the specified ID
and data.
a. Press the ID Bits softkey to select the ID number 11bits or 29 bits.
b. Press the Curr ID Byte softkey and turn the Universal Knob to select the byte to
be set.
c. Press the ID softkey and then turn the Universal Knob to set the ID
d. Press the Data1 softkey and then turn the Universal Knob to set the value of the
first byte.
e. Press the Data1 softkey and then turn the Universal Knob to set the value of the
first byte.
Error—The oscilloscope will trigger when any form error or active error is
encountered
The picture below triggers on ID, the ID is 14b2d4ff and the Band rate is 100kb/s:
Loading ...
Loading ...
Loading ...