Loading ...
Loading ...
Loading ...
Converting to LP Gas (continued)
If It IS This Regulator:
Gas Flow
into
Do not
remove this
protective cap
except for
conversion.
Lever shown closed..
PULL TO OPEN. Cap Assembly
1. Unscrew the plastic-protected hex-nut cap from the
regulator.,
2. Carefully pry the protective plastic cap off the
threaded metal cap. Gently pull the plastic washer
off the threads on the other side of the metal cap.
3. Push the plastic cap onto the end of the metal cap
displaying the type of gas you are converting too
Press the attached plastic washer onto the threads
on the other side of the metal cap.
4. Screw the hex-nut cap back into the regulator. Do
not overtighten.
Step 2
Convert The Surface Burners
Follow the directions in A for Sealed Burner Models
(models without lift-up cooktops) or B,for Standard
Twin Burner Models (models with lift-up cooktops)_
ASealed Burner Modems
(models without lift-up cooktops)
........ Grate
|
Burner Cap
Drip Pan (on some models)
Burner Head
Electrode
1, Remove grates, burner caps and burner heads°
g
=
Remove the brass orifice spud
inside the chimney of each
burner using a 9/32" or 7 mm
nut driver_
install the orifice spuds accord- Chimney
ing to one of the following dia -
grams (see [] or r_) for LP gas
or natural gas, depending on
which you are converting too
Orifice Spud
[_ Orifice Spuds for Converting to LP Gas:
LP orifice spuds are in a small plastic bag packed with
this Use and Care Manual, LP orifice spuds have a 2-
digit number and the letter "U' on top. Each orifice
spud wilt also have 1, 2 or 3 grooves on the top,
denoting the location on the range where it is to be
installed as shown below°
Front of Range
[] Orifice Spuds for Converting to Natural Gas:
Natural gas orificespuds have a 3-digit number and
the letter "N" on the top. Each orifice spud will also
have 1,2 or 3 grooves on top denoting the location on
the range where it is to be installed as shown below_
Front of Range
4. To prevent leakage, make sure the orifice spuds are
securely screwed into the gas inlet tube&
5. Put old orifice spuds back in the bag to save for
possible future conversion_
NOTE; If an orifice spud is acci-
dentally dropped, the cooktop
can be raised by disengaging the
2 front clips with a large flat blade
screwdriver.
When lowering it, make sure it snaps over the clips,
38
Loading ...
Loading ...
Loading ...