Loading ...
Loading ...
Loading ...
BnstaBIationBnsttuctWons (continued)
St®p cj
Leveling the Range
1. Remove the storage drawer, broiler drawer or kick
panel.
2. Use a 3/16" open-end or
socket wrench tO back out
both rear leveling legs
approximately two turns,
3, Use a 1%" open-end or
adjustable wrench to back
out the front leveling legs Il
two turns,. I
4. Install the oven shelves in
the oven and position the I
range where it will be
installed_
5. Check for levelness by placing a spirit level or a
cup, partially filled with water, on one of the oven
racks, tf using a spirit level, take two readingswwith
the level placed diagonally first in one direction and
then the other..
6. Adjust the leveling legs until the range is level°
7. After the range is level, slide the range away from
the wall so that the Anti-Tip device can be installed.
Step t O
lnstaBing the Anti-Tip Device
WARNING:
•Range must be secured with an approved Anti-
Tip device_.
oUnless properly installed, the range could be
tipped by you or a child standing, sitting or lean-
ing on an open door.
oAfter installing the Anti-Tip device, verify that it is
in place by carefully attempting to tilt the range
forward°
oThis range has been designed to meet all recog-
nized industry tip standards for all normal condi-
tions.
• The use of this device does not preclude tipping
of the range when not properly installed,.
o If the Anti-Tip device supplied with the range
does not fit this application, use the universal
Anti-Tip device WB02X7909.
1. Mark the wall where the RIGHT EDGE of the range
is to be located. Be sure to allow for the countertop
overhang if you intend to install the range next to
cabinets.,
=
3_
4.
_; Anti-Tip I
Slotted _.F -- lli+!-l-__ I
head O ..L ill
screw _ _ _l_'_tWallplat e I
._o__Approx_20 ° I
2_ t"
,_" (5:24Vcm) /Marked edge of range
Locate the outside edge of the device 2¼" (5°4 cm)
toward the center of the range from the marked edge
of the range,,
Using the device as a template, mark the position of
the hole for the screw.
For wood construction, drill a pilot hole at an angle of
20 degrees from the horizontal° A nail or awl may be
used if a drill is not available,.
Mount the Anti-Tip device with the screw provided.
For cement or concrete construction, you will need a
1/4" x 1t/2" tag bolt and a 1/2" O,.D. sleeve anchor,
which are not provided° Drill the recommended size
hole for the hardware°
Install the sleeve anchor into the drilled hole and then
install the lag bolt through the device. The bolts
must be properly tightened as recommended for the
hardware,
Wallboard Back ofrange
Anti-Tip
Device
Wood screw
,t
5. Slide the range against the wall, and check for
proper installation by grasping the front edges of
the rear surface unit openings and carefully
attempting to tilt the range forward.
WHEN ALL HOOKUPS ARE COMPLETED:
MAKE SURE ALL OF THE CONTROLS ARE
LEFT IN THE OFF POSITION.
MAKE SURE THE FLOW OF COMBUSTION
AND VENTILATION AIR TO THE RANGE IS
UNOBSTRUCTED.
36
Loading ...
Loading ...
Loading ...