Loading ...
Loading ...
Loading ...
Converting tG LP Gas (o,Converting Back to Natural Gas from LP)
This range leaves the factory set for use with natural gas.
If you convert to LP gas, keep these instructions and ori-
fices in case you want to convert back to natural gas.
The conversion should be done by a qualified technician
or installer
Prepare the Range for Conversion
CAUTION--Before converting the range:
(1) Turn off gas supply at the wall and
(2) Turn off the electrical power to the range.
If range has not yet been connected to gas supply, or
if flexible connection was made, range may be pulled
out from the wall to make conversion easier.
TooJs Required:
oAdjustable wrench
=1/2" open-end wrench
o Flat blade screwdriver (small)
o Nut drivers: 9/32" or 7mm (for sealed burners)
o Nut drivers or wrenches: 7mm, 5/16" or a small
adjustable (for standard twin burners)
Step t
Convert The Pressure Regulator
WARNING: Do not remove the pressure regu-
lator from the range.
1. Remove the storage drawer, broiler drawer or kick
panel and locate the pressure regulator at rear of
the range.
Remove Screws_ I
Access Cover
On some models, you may have to remove an access
cover also.
For models equipped with standard twin burners,
remove the cooktop and locate the pressure regula-
tor at the right rear of the range.
2. Follow the directions in A for Sealed Burner Models
(models without a Iift-up cooktop) or B for Standard
Pwin Burner Models (models with a lift-up cooktop)
that match your regulator type.
A Sealed Burner Models
(models without lift-up cooktops)
If It Is This Regulator:
Levershown
closed, PULL
TO OPEN,
Gas Flow into
Range
LP
nut and pin
NAT
1, Use an adjustable wrench to remove the nut from
the pressure regulator.
2. Apply sideward finger pressure to remove the plas-
tic pin from the nut.
HINT: To remove the pin, place the nut on a flat sur-
face and press the pin sideways with your fingers.
3. Push down on the disc edges to replace the pin in
the nuL
_,_ NAT
I
I
0
LP
I
4. Reinsert the assembly into the regulator.
BStandard Twin Burner Models
(models with lift-up cooktops)
If it Is This Regulator:
NAT-_ _._._ LP
Cap Cap
Gas Flow
. into Range
"_k,_ I I!_"_F-_ Lever shown
-" FuL° °sed-ENLTOOP
1. Use a Coin to remove the cap from the pressure
regulaton
2. Turn the cap over and hook it into the slots.
The type of gas to be used should now be visible
on the top of the cap.
(continued next page)
37
Loading ...
Loading ...
Loading ...