Kenmore 3627516891 gas range

User Manual - Page 29

For 3627516891.

PDF File Manual, 92 pages, Download pdf file

Loading ...
Loading ...
Loading ...
St®p t
Provide Adequate Gas Supply
Your range is designed to operate at a pressure of
4" (10,2 cm) of water column on natural gas or, if
designed for LP gas (propane or butane), 10" (25°4
cm) of water column. Make sure you are supplying
your range with the type of gas for which it is
designed. This range is convertible for use on natural
or propane gas, if you decide to use this range on a
different type of gas, conversion adjustments must be
made by a service technician or other qualified person
before attempting to operate the range on that gas,
For proper operation, the pressure of natural gas sup-
plied to the regulator must be between 4" (t0.2 cm)
and 13" (33 cm) of water column. For LP gas, the
pressure supplied must be between 10" (25_4 cm) and
13" (33 cm) of water column° When checking for prop-
er operation of the regulator, the inlet pressure must
be at least 1" (2.5 cm) greater than the operating
(manifold) pressure as given above. The pressure reg-
ulator located at the inlet of the range manifold must
remain in the supply line regardless of whether natural
or LP gas is being used., A flexible metal appliance
connector used to connect the range to the gas supply
line should have an I D, of 1/2" and be 5 feet (1 o5 m) in
length for ease of installation. In Canada, flexible con-
nectors must be single wall metal connectors no
longer than 6 feet (1,8 m) in length.
Step 2
Connect the Range to Gas
Shut off the main gas supply valve before disconnect-
ing the old range and leave it off until new hook-up
has been completed. Don't forget to relight the
pilot on other gas appliances when you turn the gas
back on.
Because hard piping restricts movement of the range,
the use of an A.G,A.-certified flexible metal appliance
connector is recommended unless local codes require
a hard-piped connection,, Never use an old connector
when installing a new range. If the hard piping method
is used, you must carefully align the pipe; the range
cannot be moved after the connection is made.
To prevent gas leaks, put pipe joint compound on, or
wrap pipe thread tape with Teflon* around all male
(external) pipe threads
*Teflon: Registered trademark of DuPont
_on_nuednextpage)
Gas Pipe and Electric Outlet Locations
for Models EquBppedwith Sealed Burners
This area allows
for flush range
installation with
through-the-wall
connectionof pipe
stublshut-off
valve and rear wall
120Voutlet
\
Shortest con-
nection from
hard pipe
stub location
to range
hookup_
(10.2
9" "_' cr
(22.9 cm)
This area allows for
flush range installation
with through-the-floor
connection of pipe
stub/shut-off valve.
Gas Pipe and Electric Outlet Locations
for Models Equipped with Dual Burners
This area allows
for flush range
installation with
through-the-
wall connection
of pipe
stub/shut-off
valve and rear
wall 120V outlet.
Shortest
/I connection
from hard pipe
30" !stub locat on
(76,2 cm) t i to range
1_ 7" hookup.
(17.8
I
(5,1 cm)
9_
(22,9 cm)
2½"
-, (6.4 cm)
This area allows
for flush range
installation with
through-the-floor
connection of pipe
stub/shut-off valve.
29
Loading ...
Loading ...
Loading ...