HC-X2 Operating Instructions / Owner’s Manual

Loading ...

Playback – Restoring clips

236

Restoring clips

In following cases, restoration of the clip may be required depending on the condition. It may take some time to restore

depending on the error.

• When the memory card in the card slot that is flashing is removed while the card 1 access lamp or the card 2 access lamp is

flashing

• When the power is turned off by removing the battery or the AC adaptor while recording or performing record completion

process

 Restoring a clip

When abnormal management information is detected, the error message [There are clips that need restoration.] is displayed on

the screen.

Select [SET] in the error message screen.

• Once the repair is completed, select [ ] in the confirmation message. It will return to the previous screen.

• is displayed on the clip when an abnormal management information is detected while displaying the thumbnail.

• Do not remove the memory card in the card slot that is flashing, or do not remove the battery or the AC adaptor when the

card 1 access lamp/card 2 access lamp is flashing in orange. Doing so will cause damage to the memory card.

• Use a sufficiently charged battery or AC adaptor.

• It may not be possible to completely repair depending on the condition of the data.

• To restore the clips, it is necessary that the clips are recorded for more than a certain amount of time. Especially in the

following cases, the clips may not be restored, because the number of frames to be recorded is small.

– When the variable frame rate recording function is enabled, and the frame rate lower than the system frequency is set.

– When the interval recording function is enabled.

• The clips shot before the power was turned off will not be able to play back if the repair fails.

Also, it may not be possible to record any more.

• If data recorded with other device is repaired, it may not be able to play back on the unit or other device.

• If the repair failed, turn off the unit, and turn it back on after waiting for a while. If the repair fails repeatedly, format with the

unit. All data will be erased when it is formatted, and it cannot be restored.

• Display of the thumbnail may become slower when the thumbnail information is repaired.

Loading ...

Operating Instructions / Owner’s Manual - Page 236