Loading ...
Loading ...
Loading ...
Calibrating Temperature
Readings
The watch’s temperature sensor is adjusted at
the factory and normally does not require
calibration. However, you can calibrate the
displayed value if you notice major errors in
readings.
Important!
●
Check to make sure that the value you
use for calibration produces correct
temperature readings.
●
Before calibrating the temperature
reading, remove the watch from your
wrist and leave it in the area where you
plan to measure temperature for about
20 or 30 minutes to allow the case
temperature to become the same as
the air temperature.
1. Enter the Barometer/Temperature Mode.
l
Navigating Between Modes
2. Hold down (A) for at least two seconds.
This displays the Barometer/
Temperature Mode setting screen.
Pointer
3. Use (A) and (D) to move the pointer to
[CALIBRATION].
4. Press (C).
5. Use (A) and (D) to move the pointer to
[THERMOMETER].
6. Press (C).
7. Use (A) and (D) to move the pointer to
[MANUAL].
●
Selecting [OFFSET OFF] returns
barometric pressure calibration to its
factory default state.
8. Press (C).
9. Repeat the steps below to change the
value.
●
Use (A) and (D) to change the
underlined value or symbol. To specify
a sub-zero value, display the minus (-)
sign.
●
Use (C) to move the underlining to the
value you want to change.
●
To stop the setting operation, press (E)
and advance to step 11.
10. After all the values are the way you want,
press (C).
11. Use (A) and (D) to select whether or not
you want to save your current settings.
[YES] Saves current settings.
[NO] Discards current settings.
[RETURN]
Return to the temperature
manual calibration screen.
12. Press (C) to complete the setting
operation.
After the setting operation is complete,
[SETTING COMPLETED] will appear for
a few seconds, and then the calibration
method selection screen will re-appear.
13. Press (E) twice to exit the setting screen.
Changing Displayed
Information
You can use the procedure below to display a
barometric pressure graph in the Barometer/
Temperature Mode.
1. Enter the Barometer/Temperature Mode.
l
Navigating Between Modes
2. Hold down (A) for at least two seconds.
This displays the Barometer/
Temperature Mode setting screen.
Pointer
3. Use (A) and (D) to move the pointer to
[SCREEN].
4. Press (C).
5. Use (A) and (D) to select a display type.
[VALUE]
Displays the latest measurement
value only.
[GRAPH]
Displays a measurement value
and a barometric pressure
graph.
6. Press (C) to complete the setting
operation.
This returns to the Barometer/
Temperature Mode setting screen.
7. Press (E) to exit the setting screen.
Operation Guide 3475
41
Loading ...
Loading ...
Loading ...