Loading ...
Loading ...
Loading ...
3. Use (A) and (D) to move the pointer to
[BARO INFORMATION].
4. Press (C).
5. Use (A) and (D) to select a barometric
pressure change indicator setting.
[ON]
Enables the barometric pressure
change indicator.
[OFF]
Disables the barometric pressure
change indicator.
6. Press (C) to complete the setting
operation.
After the setting operation is complete,
[SETTING COMPLETED] will appear for
a few seconds, and then the Barometer/
Temperature Mode setting screen will re-
appear.
7. Press (E) to exit the setting screen.
Note
●
If the barometric change indicator is
enabled, readings are taken every two
minutes even while the watch is not in
the Barometer/Temperature Mode.
●
The barometric pressure change
indicator becomes disabled
automatically 24 hours after it is
enabled.
●
Power Saving is disabled while
barometric pressure trend information
is enabled.
l
Power Saving Function
●
The barometric pressure change
indicator will become disabled
automatically when the battery
becomes [CHG] or lower.
Calibrating Barometric
Pressure Readings
The watch’s pressure sensor is adjusted at the
factory and normally does not require
calibration. However, you can calibrate the
displayed value if you notice major errors in
readings.
Important!
●
The watch will not be able to produce
correct barometric pressure readings if
you make a mistake during the
calibration procedure. Check to make
sure that the value you use for
calibration produces correct pressure
readings.
1. Enter the Barometer/Temperature Mode.
l
Navigating Between Modes
2. Hold down (A) for at least two seconds.
This displays the Barometer/
Temperature Mode setting screen.
Pointer
3. Use (A) and (D) to move the pointer to
[CALIBRATION].
4. Press (C).
5. Use (A) and (D) to move the pointer to
[BAROMETER].
6. Press (C).
7. Use (A) and (D) to move the pointer to
[MANUAL].
●
Selecting [OFFSET OFF] returns
barometric pressure calibration to its
factory default state.
8. Press (C).
9. Repeat the steps below to change the
value.
●
Use (A) and (D) to change the
underlined value.
●
Use (C) to move the underlining to the
value you want to change.
●
To stop the setting operation, press (E)
and advance to step 11.
10. After all the values are the way you want,
press (C).
11. Use (A) and (D) to select whether or not
you want to save your current settings.
[YES] Saves current settings.
[NO] Discards current settings.
[RETURN]
Return to the barometric
pressure manual calibration
screen.
12. Press (C) to complete the setting
operation.
After the setting operation is complete,
[SETTING COMPLETED] will appear for
a few seconds, and then the calibration
method selection screen will re-appear.
13. Press (E) twice to exit the setting screen.
Operation Guide 3475
40
Loading ...
Loading ...
Loading ...