Loading ...
Loading ...
Loading ...
CUTTINGWARPEDMATERIAL (Flgo 19 and 20)
Z_WARNING: To avoid kickback and to avoid serious personal Injury
NEVER position the concave side of bowed or warped material against the
fence,
When cutting warped material, BE CERTAIN that the mateda[ to be cut is positioned
on the miter table with the convex side against the fence, as shown (Fig. 19)
If the warped material is positioned the wrong way, (Fig 20), it will pinch the blade
near the and of the cut.
Fig.19 TopvJ_v
Rtght
F{go20
W_ong
Z_WARNING; To ensure safety and rellabllity_ all repairs - with the
exception of the externally accessible brushes * should be performed by a
qualified service technfc_an at a Sears Service Center
z_WARNING: For your safety, ALWAYS turn off switch and unplug miter
saw from the power source before performing any maintenance or cleaning
Electric tools are subject to accelerated wear and possible premature failure when
they are used to work on fiber glass boats and sports cars, waflboard, spackling
compounds or plaster The chips and grindings from these materials are highIy
abrasive to electflcal tool parts, such as bearings, brushes, commutators, etc
Consequently, it Is not recommended that this loci be used for extended work on any
fiberglass material, wallboard, spackling compound or plaster During any use on
these materiels, It is extremely Important that the tool is cleaned frequently by
btow[ng with an air jet
] _WARNING: Always wear safety goggles or safety glasses with side
shields during power tool operations, or when blowing dust,. If operation ls
dusty, also wear a dust mask.
35
Loading ...
Loading ...
Loading ...