Loading ...
Loading ...
Loading ...
CROSSCUTTINGcont. (Ffg, 13 and I4)
Z_WARNING: To avoid serious personal injury, ALWAYS keep your hands
outside the "no hands zone", as marked on the saw table, which is at least 3
inches from the blade.. Also, NEVER perform any cutting operation "freehand"
(i.e. without holding the workpiece against the fence); the brads couid grab the
workptece, causing it to slip and twisL
t2. BEFORE turning on the saw, perform a dry run of the cutting operation by
towering the saw arm to make sure that no problems will occur when the cut
is made
13 Hold the saw handle and use your index finger to turn on the laser switch by
pushing it forward,
14 To turn on saw, push the safety lock button in wilh your thumb while squeezing
the On!Of! {rigger switch tocated under the handle (Fig la and lb) Allow several
seconds for the blade to reach maximum speed.
15. Slowly lower the blade into and through the workpiece.
16 Re,ease the safety lock and trigger switch and turn off the laser switch Allow the
saw biade to stop rotating BEFORE raising the blade out of the workpteee
BEVEL GUTTING (FIg. tS) _ _ _
A bevel cut is a cut made across the Fig,, I5
grain of the workpiece with the blade !{ /._--_ _"_ 17 m
A straight bevel cut ts made w{th the
miter table set tn the 0° position and
the saw arm set at a bevel angle
between 0" and 45"
To Bevel Cut With Your Miter Saw _/t.._ =' _ '
1 Unplug the saw
=4s_BevelOut l
L /_ I ...-q..!
z_ WARNING; Failure to unplug your saw could result in accidental starting
causing serious injury.
2 Make sure the miter table is at 0_ and }ocked, and check that the miter table lock
lever isdown and secured in position
Z_WARNING: To avoid serious personal injury, ALWAYS tighten the miler
_ock lever securely BEFORE making a cut. Failure to do so could result in
movement of the control arm or miter table while making a cut,.
28
Loading ...
Loading ...
Loading ...