Loading ...
Loading ...
Loading ...
SQUARING THE SLA DETOTHE
MITERTABLE 0" Bevel, 0° Miter
(Fig. 6)
Z_WARNING: Failure to l
unplug your saw could result in
accidental starting causing
serious Injury.
t Set the bevel and miler angle
scales to 0_and lock in place
2 Lower and lock lhe saw arm inie
the "DOWN" position
3 PIacea combination square on the
miter table wilh the rule against the
table and heel of the square
against the sew blade
I NOTE; Be sure to rest the
square against the body of the
blade and not against the teeth
of the blade.
4 ff the blade is nol 90° square with
the miter labte, peflorm sleps 5
thro'_Jgh8
5 Loosen Iocknut "A" wilh a 10 turn
wrench (This is lhe outer part of
lhe bevel angle screw "A").
Fig. 6
BILtde 90 _ Squats
to Miter Tabte
eeve_ Lock Kneb
_,, J_,.4" ecrewA [[(7 f'_ _ Support
This screw ts to your left as you face the back of the saw,
6 Loosen bevel lock knob then square the blade to lhe labia by adiustlng the set screw
(inside of bevel angle screw "A") clockwise or counlerdockwise wilh a 3 mm he× key
You may have to move Ihe saw arm by hand It may help to hold the lock nut in place
with the wrench, while turning lhe set screw
7 Once the angle is set, tighlen the lock nul with the wrench while holding the set
screw in place wilh lhe hex key
8 Lock the bevel knob
BEVEL ANGLE INDICATOR ADJUSTMENT
(Fig. 6a) If Necessary
1 Check to see if the bevel angle indicator is
pointing to 0° on the bevel scale
2 If the indicator isnot on 0 _,loosen the bevel
angte indicator screw, adjust the indicator
to 0"_on bevet angle scale, lighten screw
Fig, 6a
21
Loading ...
Loading ...
Loading ...