Loading ...
Loading ...
Loading ...
THROAT PLATE SLOT (Fig, 7)
The th;roatplate was cut (slotted) at the
factory' for a 0= bevel/miter cut
The first cut you wifl make with the saw will
be to increase this slot in the throat plate by
setting the bevel scale to 45°, locking the bevel
lock knob into position and cutting into the
throat piate, increasing the width of the sIot
ADJUSTING THE BLADE TO THE
MITER TABLE 45 ° Bevel, 0=MITER
(Fig° 8)
/k WARNING: Failureto
unplug your saw could resul! in
accidental starting causing
serious injury°
1 Raise the sew arm
2 Set the bevel angle scale to 45'_
The miter scale should be on 0"
Lower and lock the saw arm into tile
"DOWN" position
3 Place a combination square on the
miter table with lhe rule against lhe
1able and heel of the square
against the saw blade
I OTE: Be sure to rest the square
against the body of the b}ade
and not against the teeth of the
blade.
4 If the b_ade is not 45" square with_h'e
miter labia, perform slops 5 through 8
5 Loosen lock nut "B" with a 10 mm
wrench (This is the outer part o! the
bevel angle screw "B").
This screw is to your right as you
face the back of the saw,
Fig. 8
6 Loosen bevel lock knob, than adiust lhe blade to 45" by adjusting the set screw
(inside of bevel angle screw "B") ctockwiss or counterclockwise with 3 mm hex key
You may have to move the saw arm by hand _tmay help to hold the lock nul in place
w{lh the wrench while turning the set screw
22
Loading ...
Loading ...
Loading ...