Loading ...
Loading ...
Loading ...
3433
8. Correct Temperature：
An indication of reaching correct milk
temperature is when the Milk Jugbase
can only be touched comfortably for
approximately 3 seconds.
Barista Tip: Milk Temperature
- Under: If not heated long enough,
it will be warm with little texture.
- Optimum: See below table.
- Over: If heated for too long it will
start to boil around 72°C and will
have a burnt taste with all texture
lost.
Full & Skim60-65°C(140-149 ℉)
MILKTEMPERATURE
Almond55-65°C(131-149 ℉)
Soy55-60°C(131-149 ℉)
Coconut65-70°C(131-149 ℉)
Above recommendations might
vary from one milk brand to
another and depending on your
taste preference.
NOTE
11. Tap & Swirl the Jug ：
Gently tapping the Jug on the benchtop
helps to release larger trapped air bub-
bles. Swirling helps the milk & froth
to combine for an even consistency &
a silky appearance.
vertical position and remove the Milk
Jug from the Steam Wand. Place Milk
Jug to one side. Place the Steam
Wand over the Drip Tray . Turn the
DIAL to the HOT WATER position for
a few seconds, then return the DIAL
to the vertical position. This will
remove any milk that has been
sucked into the Steam Wand Tip.
10. Wipe Steam Wand：
Wipe the Steam Wand Arm & Froth
nozzle with a clean damp cloth to
remove any milk residue.
12. The Finishing Touches：
Pour from the Milk Jug into your cup
in one steady motion.
7.3 Operation
Milk temperature from 140-149°F
is recommended for milk frothing,
or you can increase or decrease
the temperature to better suit
your taste.
NOTE
1. Check Water
As with NTC precision thermostats,
the espresso extraction temperature
is controlled at 197℉, while the
milk frothing temperature is at 212°F.
TIPS
Before insert the refill water tank,
use the clean cloth to wipe off the
water on the valve.
If the temperature is too high to
make espresso, the steam will
splash from the portafilter and
hot water will drip off. It will result
in a small amount of coffee and a
bad taste.
When the water tank is pulled up,
the water will flow out from
theoutlet at the bottom of the
water tank, as it is a movable part.
If you have pulled up several times
and have not wipe the water
immediately,it will accumulate
more and more and ran to the
bottom of the machine, maybe
will leave the table full of water.
It's not leaking.
NOTE
MAX 2.8L
Fill water into the water tank NOT
exceed the MAX line. Set up the
water tank vertically and align
the bucklesto the hole on the
back of themachine,and press
it down to beparallel to the top
of the machine.
7. Milk Frothing Guide7. Milk Frothing Guide
9. Purging the Steam Wand：
When correct milk temperature has
been reached, turn the DIAL to the
Loading ...
Loading ...
Loading ...