Loading ...
Loading ...
Loading ...
4. Loosen two screws on scale and adjust scale
until POINTER points to 45 ° mark.
5. install Elevation Handwhee!.
-_ ADJUST NG/I
....... i SI I CREW
...SCALE _ / /
TnLT MECHANISM
The handwheet should turn freely without binding.
The turning action can be adjusted by tightening or
loosening the screws in the bearing retainer.
NOTE: Tilt Handwheel must be removed to adjust.
When adjusting the screws in the bearing retainer,
hold the nut inside using a 3/8 in. wrench.
_ ADJUST THESE
TWO SCREWS
TILT HANDWHEEL
/
SET SCREW
MAINTENANCE
I WARNING: For your own safety, turn switch I
"OFF"and remove plug from power source outlet
h
before maintaining or lubricating your saw.
Do not allow sawdust to accumulate inside the saw.
Frequently blow out any dust that may accumulate
inside the saw cabinet and the motor.
Frequently clean your cutting tools with Craftsman Gum
and Pitch Remover.
A coat of furniture type wax applied to the table wi]l help
to keep the surface clean and allow workpieces to slide
more freely.
If the power cord is worn or cut. or damaged in any way,
have it replaced immediately
Make sure the teeth of the ANTI-KICKBACK pawls are
always sharp. To sharpen:
1. Remove blade guard.
2. Rotate pawl toward rear of spreader so that teeth are
above top of spreader.
3. Hold spreader with left hand and place pawl over
corner of workbench,
4. Using a small round file (Smooth Out) sharpen the
teeth.
57
Loading ...
Loading ...
Loading ...