Loading ...
Loading ...
Loading ...
5. Turn front bar end for end and insert two of the
bolts through holes on teftside of front edge on saw
table. The third screw is inserted through the bracket
installed earlier
6. Install lockwashers and nuts on bolts. DO NOT
SCREW NUTS ON ALL THEWAY,just get them started
on the screws.
SCREWS LOCATED
HERE
iNSTALLING REAR FENCE GUIDE BARS
1. From among the loose parts find the following:
2 Brackets
4 Hex Head Screws 5/16-18 x 1 in. long
4 Hex Head Screws 5/16-18 x 3/4 in. long
8 Flat Washers (dia. of hole 21/64 in.)
8 External Lockwashers, 5/16 in.
8 Hex Nuts, 5/16-18
2 Rear Fence Guide Bars
4 Protective Caps
5/16-18 x 3/4
HEX HEAD
SCREW
5/t 6 IN
FLAT WASHER
REAR FENCE GUIDE BAR
EXTERNAL 5/16-18
LOCKWASHER HEX NUT
BRACKET
5/16-18 x 1 IN
HEX HD. SCREW
EXTERNAL
LOCKWASHER
2. Put one of the brackets against the right rear
edge of the right extension so the bracket is lined
up with the FOURTH hole near the rear of the
extension (see illustration).
3. Insert one of the 3/4 inch long screws through a flat
washer, through the bracket, and through the
FOURTH hole in the extension. Install a Iockwasher
and nut on the screw. Tighten the nut only slightly
4. Install the other bracket against the left side of
the left extension using the same procedure
explained above.
PROTECTIVE CAP
REAR OF
5/16-18x3/4
HEX HEAD
SCREW
5. Layone rearfenceguidebarontheleft rearsideofthe
saw table as illustrated (as viewed from rear of the
saw). Insert a I inch long screw through a flat washer
and throughthe SECOND hole of the rear fence guide
bar. Insert a 1 inch long screw through a flat washer
andthroughthe FOURTH hold. Insert a3t4 inch long
screw through a flat washer and through the
ELEVENTH hole.
2ND HOLE 4TH HOLE
WASHER
HEX HEAD
SCREW
5/15-18 X 1 IN
WASHER
BACK OF SAW
tlTH HOLE
l
HEX HEAD
SCREW
5,'16-18X 3/4 IN
19
Loading ...
Loading ...
Loading ...