Loading ...
Loading ...
Loading ...
MOUNTING SAW
1. From among the loose parts, find the following
hardware:
4 Hex Head Screws, 5/16-18 x 1-1/4 in. long.
4 Hex Nuts, 5/16-18 (approx. dia. of hole 5/16 in.)
4 Lockwashers, 5/16 in. External Type (approx.
dia. of hole, 5/16 in.)
8 Flat Washers, (dia. of hole !1/32 in.)
WARNING: The saw is heavy. To avoid back
injury, get help to rift the saw. Hold the saw close
to your body. Bend your knees so you can li_twith
your legs, not your back.
_N
HEX HEAD SCREW
5/16 IN
LOCKWASHER
5/16 - 18
HEX NUT
11/32 IN
FLAT WASHER
2. Place saw on legs so that holes in bottom of saw
line up with holes in top of assembled leg set.
3. Install screws, washers, Iockwashers and nuts as
shown below.
If you mount the saw on any other bench, make sure
there is an opening in the top of the bench the same
size as the opening in the bottom of the saw so that
the sawdust can drop through. Recommended
working height is 33 to 37 inches from the top of the
saw table to the floor.
SAW BASE
FLAT WASHER
END l ...'
STIFFENER--_I _ _
LOCKWASHER /_m==_ l!
HEXNUT
/
13
i
2-3/4
7/16 DIA. HOLES
11-1/4
'_L_PENIN?/
\
16 13
°
/
/
/
/
\/
\
\
\
Q Y
!
--RONT OF SAW __
1/2
NOTE: All dimensions in inches
15
Loading ...
Loading ...
Loading ...