Loading ...
Loading ...
Loading ...
4. The guide bar you stacked washers against n
step 3 must now be removed so stacks of washers
can be installed. To do so remove nuts and
Iockwashers from tWO screws that hold the guide
bar to front edge of table. Pull guide bar away
from table and put one stack of washers on each
bolt between spacerand front edge of table - see
illustration. Put guide bar back in place on front
of table and reinstall [ockwashers and nuts on
two bolts - do not tighten at th is time
VIEW FROM TOP OF SAW
©
HEX NUT
STACK OF
WASHERS -
SPACER
TABLE
EXTERNAL
;HER
5. Any of the six (6) screws holding the two t21 front
rip fence guide bars in place, that were earlier
tightened us=ng a wrench_ must now be loosened
and retightened so they are only hand tight
Position rip fence over the right miter gauge
groove. While holding up rear end of Np fence.
engage front end of rip fence onto r=p fence
guide bar. Now lower rip fence down onto table
6. Cut up a piece of newspaper in to 16 equally s=zed
pieces about 4 inches square. Separate these
pieces into two stacks containing 8 p_eces m
each stack. P.ut one stack under rear end of rIp
fence and other stack under front end of rip fence
- see illustration.
OF PAPER
t
7: Raise or lower left end of right front rip fence
guide bar just enough to aliov_ paper stack (at
front of rip fence) to slide back and forth under
rip fence. Keep guide bar in this position and
tighten screw at the far left of this guide bar.
8. Pushthe left rear (as viewed from rear of saw) fence
will go. Raise or lower right end of left rear rip fence
allow stack of paper(at rear of fence) to slide back
and forth under the rip fence. Hold guide bar in this
position and tighten screw at far right of this guide
bar.
PAPER SHOI
SLIDE EASILY
SCREW AT
FAR LEFT END
OF RIGHT FRONT
GUIDE BAR
PAPER STACK
22
Loading ...
Loading ...
Loading ...