Loading ...
Loading ...
Loading ...
If blade is NOT SQUARE to table.. _the g0° stop
screw must be ADJUSTED.
A. Unscrew 90 ° STOP SCREW three to four turns
using 3/16 in. Hex "L" wrench.
B. Turn tilt handwheel clockwise one turn, then turn
handwheel counterclockwise until blade is square
with table.
C. Screw 90° stop screw IN until it stops .. check
once again for squareness and readjust screw, if
necessary.
/
/
/
90°
_TOPSCREW
450 POSITION
TILT blade to LEFT as far as it will go.
A. Place an ACCURATE square against blade.
Make sure square is not touching the TIP of
one of the saw TEETH.
If blade is 45° to table;
A. Check pointer.
|
It POINTER DOES NOT point to the 45 ° mark on the
scale; -_
A. Remove Elevation Handwheel.
B. Loosen two screws on scale and adjust scale
until POINTER points to 45° mark. "\.
C. Install Elevation Handwheel \SCALE /
ADJUSTING
SCREW
If blade is NOT 45 ° TO TABLE... STOP SCR EWand
SCALE must be ADJUSTED.
1. Unscrew 45 ° STOP SCREW three to four turns
using 3/16 in. setscrew wrench.
2. Turn tilt handwheel until blade is45 ° tothetable. /
/
3, Screw 45 ° stop screw IN until it stops., check
once again and readjust screw, if necessary. /
/
/
\
$6
Loading ...
Loading ...
Loading ...