Loading ...
Loading ...
Loading ...
OPERATION
OvenControl, Clockand Timer
Your new control has a series of
tones that will sound at different times,
These tones may sound while you set
the control for an oven function, or at
the end of the oven function, It will
also alert you that there may be a
problem with the functions. Below
are the types of tones and a brief
description of each,
TONES WHILE SETTING THE
CONTROL - When you touch a pad,
you will hear a beep. This beep will let
you know that the pad has been
activated, (The arrow pads do not
beeF)
END OF TIMED CYCLE TONE - At
the end of a timed cooking function,
you wilt hear 3 short beeps followed
by 1 beep every 6 seconds, This
beep will continue to sound every 6
seconds until the CLEAR/OFF pad is
touched or you may select the special
feature to cancel this 6-second beep
from sounding at the end of future
cycles.
TO CANCEL THE 6-SECOND BEEP
li Touch and hold the BAKE and
BROIL pads, at the same time
for 3 seconds, until the display
shows "SF"
2, Touch the KITCHEN TIMER ON/
OFF pad, The display will show
"CON BEEP" (continuous beep),
3, Touch the KITCHEN TIMER ON/
OFF pad again, The display will
show "BEEP" (beep canceled)
4. Touch the START pad to cancel
the 6-second beep and leave the
special feature mode,
If you would like to return the
6-second beep, repeat steps above
until the display shows your choice
and touch the START pad.
ATTENTION TONE - This tone will
sound if you make an error or an
oversight is made while setting an
oven function,
Examples would be:
a. Setting a clean cycle and the oven
door is not properly closed
b. Setting function and not pressing
the START pad.
c. Touching an additional function
pad without first setting a
temperature or time,
d, "ERR" will flash if you set an
invalid temperature. Touch the
CLEAR/OFF pad to clear the
control and reset your oven
function.
Any of these can be quickly identified
by watching the display.
PREHEAT TONE - When you
set an oven temperature, the oven
automatically starts to heat, When the
temperature inside the oven reaches
the temperature you have set, a tone
will sound to let you know the oven is
ready for baking,
If you set an oven function and the
control beeps while the display is
flashing "F" and a number or letter
such as "F-4" or "FI," there may be
a problem with the control or oven,
Touch the CLEAR/OFF pad. If the
function code repeats, disconnect
all power to the range for at least
30 seconds and then reconnect the
power. Try setting the function again
If the code repeats again, write down
the flashing code and call for service.
Tell the technician what code was
flashing
16
Loading ...
Loading ...
Loading ...