Loading ...
Loading ...
Loading ...
_ @00N RX-VI400U EN.book Page 60 Thursday, July 10, 20(13
12:17 AM
+
You can control other components by setting the
appropriate manufacturer codes. Codes can be set up for
each input m'ea.
The following table shows the default component
(Library: component calegory) and the manufacturer code
for each area.
Component
Input area category Manufacturer
(Library)
PHONO TV
TUNER TUNER Yamaha- 1
CD CD Yamaha- 1
V-AUX VCR
CBL/SAT CABLE
MD/TAPE MD Yamaha- 1
CD-R CD-R Yamaha
DTV TV
VCR 1 VCR -
DVR!VCR2 VCR -
DVD DVD Yamaha- 1
You may not be able to operate your Yamaha component even if
Yamaha manuf)cture code is initially set as listed above. In this
case, try to set other Yamaha manufactm'e code(s).
1 Press an input selector button to select the
source component you want to set up.
© °©" ©I r,i,r
2 Press and hold LEARN for about 3 seconds
using a ballpoint pen or similar object.
"SETUP" and the selected component name appear
alternately in the display window.
- I
BiUI)
Be sure to press and hold LEARN for at least 3
seconds, otherwise the learning process will stm't.
g+,,
Complete each of the following steps in 30 seconds.
Otherwise, the learning mode will be auiomatically
canceled. In this case, press LEARN again.
3
4
If you want to change a library (component
category), press < / ). You can set a different
type of component.
Library choices: L:DVD, L:LD, L:CD, L:CDR,
L:MD, L:TAP (tape), L:TUN, L:AMP*, L:TV,
L:CAB (cable), L:DBS, L:SAT, L:VCR
* The amplifier Library (L:AMP) code is preset to "YPC"
to operate this unit. However, you can switch between the
tMlowing two codes if necessary.
• The initial setting for "Amplifier library" is "YPC".
YPC To operate this unit.
Z0NE (U.S.A., Canada and Australia models only)
To operate ZONE 2 or ZONE 3 teaiures.
Press/x / v to select the name of your
component's manufacturer.
You will find the names of most worldwide audio=
video manufacturer,s in alphabetical order in the
display window.
r
i
I i
Press one of the buttons shaded below to
see if you can control your component. If you
can, the manufacturer code is correct.
g+,,
• If the manufacturer of your component has more than one
codes, try each of them until you find the correct one.
• If you continuously want to set up another code t_,)r
another component, press TV MUTE/SELECT and repeal
steps 1,3 and 4.
+
60
Loading ...
Loading ...
Loading ...