Loading ...
Loading ...
Loading ...
_ @0(t RX-VI400U EN.book Page 12 Thursday, July lU, 20(13
12:17 AM
Be sure to connect the left channel (L), right channel (R),
"+" (red) and "-" (black) properly. If the connections are
faulty, no sound will be heard from the speakers, and if the
polarity of the speaker connections is incorrect, the sound
will be unnalural and lack bass.
5 Tighten the knob to secure the wire.
4
I[_JIJi!aJ/l
• If you will use 6 ohm speaker,s, be sure to set this unit's
speaker impedance setting to 6 ohms before using (see
page 23).
• Before connecting the speakers, make sure that the
power of this unit is off.
• Do no1 let the bare speaker wires touch each other or do
not let them touch any metal pm't of this unit. This
could damage this unit and/or speakers.
• Use magnetically shielded speakers. If this type of
speaker,s still creates the interference wilh the monitor,
place the speakers away from the monilor.
A speaker cord is actually a pair of insulated cables
running side by side. One cable is colored or shaped
differently, perhaps with a slripe, groove or ridges.
Connect the striped (grooved, elc.) cable to the "+" (red)
terminals on this unit and your speaker. Connect the plain
cable to the "-" (black) lerminals.
2
1 Remove approximately 10 mm (3/8") of
insulation from each of the speaker cables.
2 Twist the exposed wires of the cable together
to prevent short circuits.
3 Unscrewthe knob.
Supplied speaker terminal wrench is useful to screw or
unscrew knobs.
4 Insert one bare wire into the hole in the side
of each terminal.
Red: positive (+)
Black: negative (-)
Connecting to PRESENCE/ZONE 2 or PRESENCE
speaker terminals
1 Open the tab.
2 Insert one bare wire into
the hole of each terminal,
3 Return thetab to secure
the wire.
Banana plug connections
(With the exceplion of U.K., Europe and Asia models)
First, tighlen the knob and then insert the banana plug
connector into the end of the corresponding terminal.
Banana plug
(With the exception of U.K., Europe
and Asia models)
12
Loading ...
Loading ...
Loading ...