Loading ...
Loading ...
Loading ...
_ @0(t RX-VI40(IU EN.book Page 4(I Thursday, July 10, 20(13
12:17 AM
+
Recording adjustments and olher operations are
performed from the recording components. Refer to the
operalion instructions for those components.
2
(U.S.A. model
1
1 Turn on the power of this unit and all
connected components.
2 Select the source component you want to
record from.
O
Front panel
or
Remote control
3 Start playback (or select a broadcast station)
on the source component.
4 Start recording on the recording component.
• Do a test rec_rding be_k_reyou start an actual recording.
• When this unit is set in the standby mode, you cannot record
between other components connected to this unit.
• The setting of TONE CONTROL, VOLUME, "Speaker level"
(page 50) and programs does not affect the recorded material.
• A source connected to the MULTI CH INPUT jacks of this unit
cannot be recorded.
• S-video and composite video signals pass independently
through this unit's video circuits, Therefk_re, when recording or
dubbing video signals, if your video source component is
connected _o provide only an S-video (or only a composite
video) signal, you can record only an S-video (or only a
composite video) signal to your VCR.
• A given input soarce is not output on the same REC OUT
channel. (For example, the signal input from VCR 1 IN is not
output on VCR 1 OUT.)
• Check the copyright laws in your country to record flora
records, CDs, radio, etc. Recording of copyrighted material may
inf¥inge copyright laws.
If you playback a video source that uses scrambled or
encoded signals to prevent it from being dubbed, the
picture itself may be disturbed due to those signals.
• Special considerations when recording
DTS software
The DTS signal is a digital bit slream_ Attempting to
digitally record the DTS bit stream will result in noise
being recorded. Therefore, if you want 1o use this unit to
record sources that have DTS signals recorded on them,
the following considerations and adjustments need 1o be
made.
For LDs, DVDs and CDs encoded with DTS, when your
player is compatible with the DTS formal, follow its
operation instruction to make a setting so that the analog
signal will be oulput from the player.
+
40
Loading ...
Loading ...
Loading ...