Yamaha RX-V1400 receiver

User Manual - Page 25

For RX-V1400.

PDF File Manual, 92 pages, Download pdf file

Loading ...
Loading ...
Loading ...
_ _00 RX-VI400U EN.book Page 21
Thursday, July 10,2003 12:17 AM
Iph%,l_Btll[OhTl
+
Both AM and FM indoor antennas are included with this
unit. In general, these anlennas should provide sufficient
signal strength. Connect each anlenna correctly Io the
designated terminals.
AM loop antenna Indoor FM antenna
(included) (included)
Ground (GND terminal)
Fur maxintum safety and ndnimum inler ference,
connect die antenna GND tel mina] Io a good eardl
ground. A good earth ground is a metal stake driven
]ntu moist earth.
Connecting the AM loop antenna
1 Set up the AM loop antenna, then connect it
to the terminals on this unit.
2 Press and hold the tab to insert the AM loop
antenna lead wires into the AM ANT and GND
terminals.
3 Orient the AM loop antenna for the best
reception.
The AM loop antenna should be placed away fl'om this unit.
The AM loop antenna should always be connected, evenif a_
outdoor AM antenna is connected to this unit.
A property installedoutdoor antenna provides clearer reception
than an indoor one. ff you experience poor reception quality, an
outdoor antenna may improve the quality. Consuh the nearest
authorized YAMAHA dealer or service center about outdoor
al/|e]!]las.
75-ohm/300-ohm antenna adapter
(U.K. model only)
1 Open the cover of the
included 75-ohm/300-ohm
antenna adapter.
2
Cut the external sleeve
of the 75-ohm coaxial _i (7/16)
8 (5116) Unit:
cable and prepare it for 6 (I/14) mm (inch)
connection.
3 Cut the lead wire and
remove it.
4
5
Insert the cable _ _
wire into the slot, Clamp _ Clamp
and clamp it with
pliers.
Insert the wire
into slot.
Snap the cover
into place.
FREQUENCY STEP switch
(General models only)
Because the interstation frequency
spacing differs in different areas, set
the FREQUENCY STEP switch
(locating on the rear panel) according
to the frequency spacing in your area.
North, Central and South America: 100 kHz/10 kHz
Other areas: 50 kHz/9 kHz
Before setting this swilch, disconnect this unit's AC power
cord from the wall outlet.
+
21
Loading ...
Loading ...
Loading ...