Loading ...
Loading ...
Loading ...
Thefastpreheaticon_'appearsinthedisplayjust
abovethemodename.
PressStart.
Iftheprobetemperatureenteredisoutsidethisrange,
anerroris displayed.
,
Fast Preheat can be turned off by pressing Fast Preheat
again.
Special Features
,
The probe current temperature and target temperature
are both displayed in the format "105/180" at the lower
right corner of the display. The actual temperature will
display < 80 until the food temperature reaches 803 F.
The displayed probe temperature is updated in
increments of 5° during the cooking process.
The special features provide you with additional
conveniences when cooking.
Learn more about these special features in the following
sections:
• Probe (some models)
• Sabbath Mode
• PanelLock
Probe (some models)
The probe measures the internal temperature of the food.
The probe is available for Bake, Roast and all convection
cooking modes except Convection Broil.
Inserting the probe:
Insert the tip of the probe in the middle and thickest part of
the meat. Make sure the probe is not touching fat, bone, or
parts of the oven or the pan.
To use the probe:
1. Insert the probe into the meat as described above.
2. Connect the probe to the oven. If the probe is not
connected to the oven prior to starting Probe mode, an
error tone sounds and the message "INSERT PROBE"
is displayed.
3. The Set Probe Temp screen is displayed. A three digit
input prompt "- - -" blinks in the lower right corner. Use
the numeric keypad to enter the desired probe
temperature and press Enter on the numeric keypad.
4. Set the cooking mode and temperature.
Note: The minimum probe temperature that can be set
is 100° F (40 ° C) and the maximum is 200 ° F (100 ° C).
,
When the probe temperature reaches the set
temperature, the cooking mode turns off. The current
time is displayed and the message "COOKING
COMPLETE" blinks at the bottom left of the display. An
alarm tone sounds every 10 seconds for 2 minutes.
....i
This screen remains in the display until it is cleared by
pressing the Oven Clear/Off touchpad or until the
probe is removed. The display then goes back to stand
by mode.
Note:
• Probe is not available when an Oven Timer has been
set.
• To change the probe temperature press the Probe
touchpad. The display enters probe temperature
editing mode and displays the message "SET PROBE
TEMP". Enter the new probe temperature and press
Enter to accept the new value.
• Do not store the probe in the oven.
• Always use the handle of the probe for inserting and
removing.
• Always use a potholder to remove the probe since it
becomes hot.
English 18
Loading ...
Loading ...
Loading ...