Loading ...
Loading ...
Loading ...
155
Care and storage
Post-operation care
Flushing the cooling system
Cooling system flushing is essential to pre-
vent the cooling system from clogging up with
salt, sand, or dirt.
(1) Connect the garden hose adapter to a
garden hose.
1 Garden hose adapter
(2) Loosen the flush hose connector cap for
the engine you are going to flush and re-
move it. Insert the garden hose adapter
into the flush hose connector by pushing
and twisting it until it is securely connect-
ed.
1 Flush hose connector
2 Flush hose connector cap
3 Garden hose adapter
(3) Connect the garden hose to a water tap.
(4) Make sure that the area around the boat
is clear, and then start the engine. Imme-
diately after the engine starts, fully turn
the water supply on so that water flows
out continually from the jet thrust nozzle
and cooling water pilot outlet. NOTICE:
Never turn on the water before starting
the engine. The water could flow back
through the muffler into the crankcase
causing severe engine damage. Be
sure to turn on the water immediately
after starting the engine to prevent en-
gine overheating.
(5) Run the engine at a fast idle for 3 to 5
minutes. If the engine stops while flush-
ing, turn the water supply off immediately
and perform the procedure again from
step 4.
(6) Turn off the water supply, and then drain
residual water from the exhaust system
by alternately pushing the remote control
1
1
3
2
SportsBoat_F3R10.book Page 155 Monday, June 27, 2016 3:22 PM
Loading ...
Loading ...
Loading ...