Loading ...
Loading ...
Loading ...
Checking and refilling levels
Check the condition of all seat belts at regu-
l
ar int
er
vals.
Very soiled belts may not retract properly.
WARNING
●
The seat belt
s should never be removed
from the vehicle for cleaning.
●
Never clean using chemical products, as
chemical detergents destroy the fabric. En-
sure that the seat belts do not come into con-
tact with corrosive fluids such as acids, etc.
●
If you find any damage to the belt webbing,
belt fittings, the belt retractor or the buckle,
the belt in question must be replaced by an
Official Service.
●
Make sure that the inertia reel seat belts
are completely dry before allowing them to
retract.
Checking and refilling levels
F
uel
R
ef
uelling
Fig. 202 Vehicle as seen from the rear right:
f
uel
t
ank flap/fuel tank flap with tank un-
screwed cap attached.
Read the additional information carefully
›
›
›
page 40
The correct type of fuel for your vehicle is in-
dicated on a sticker on the inside of the fuel
tank flap, along with the tyre size and pres-
sure ››› Fig. 202 .
Vehicles with a fuel cap with key
–
Press the flap in the direction of the arrow
1
›
›› Fig. 202
.
–
Open the c
over in the direction indicated
by the arrow
2
.
–
Hold onto the fuel tank cap with one hand
and u
n
loc
k it using the ignition key, turning
it anti-clockwise.
–
Unscrew the tank cap anti-clockwise and
place it on top of the tank flap ››› Fig. 202
.
–
Insert the pump nozzle into the fuel feed
tube as far as it will go.
The fuel tank is full as soon as the automatic
filler nozzle cuts out ›››
.
–
Remove the pump nozzle from the fuel feed
t
ube and p
l
ace it back on the pump.
–
Screw the tank cap clockwise until it clicks
into place.
–
Hold onto the fuel tank cap with one hand
and lock it using the ignition key, turning it
clockwise.
–
Press the tank flap with your hand to close
it.
»
201
Technical dataAdviceOperationEmergenciesSafety
Loading ...
Loading ...
Loading ...