Loading ...
Loading ...
Loading ...
Lights and visibility
Note
Please observe any relevant legal require-
ments whic
h may apply in your country.
Turn signal and main beam headlights
lever
Fig. 133 Turn signal and main beam lever.
The turn signal and main beam lever also op-
er
at
e
s the parking lights and the headlight
flasher.
Right and left-hand turn signal
●
Move the lever ››› Fig. 133 up
1
or down
2
.
●
Keep the lever held down at the point of re-
s
i
s
tance for the turn signals to flash for as
long as you hold the lever, e.g. when chang-
ing lanes.
Convenience turn signals
For the convenience turn signals, move the
lever as far as possible upwards or down-
wards and release the lever. The turn signal
will flash three times.
The convenience turn signals are activated
and deactivated in the Easy Connect system
via the
button and the
S
ET
TINGS
function
b
utt
on ›
›› page 101.
In vehicles that do not have the correspond-
ing menu, this function can be deactivated in
a specialised workshop.
Main beams
●
Switch on the dipped beam ››› page 121.
●
Press the lever ››› Fig. 133 forward in the di-
rection indicated by arrow
3
.
●
Pull the lever back to its original position in
the dir
ection indic
at
ed by arrow
4
to switch
the m
ain be
am off
.
Headlight flasher
●
Pull the lever ››› Fig. 133 towards the steer-
ing wheel (point of resistance) in the direc-
tion indicated by arrow
4
.
P
ark
in
g lights
●
Instructions for use ››› page 126.
CAUTION
Never use the main beam headlights or the
headlight
flasher if they could dazzle other
drivers.
Note
●
If the con
venience turn signals are operat-
ing (three flashes) and the other convenience
turn signals are switched on, the active part
stops flashing and only flashes once in the
new part selected.
●
The turn signals only work when the igni-
tion is switched on. The corresponding warn-
ing lamp or flashes in the general instru-
ment panel.
●
The turn signals switch off automatically
when the steering wheel is returned to the
straight-ahead position.
●
If a turn signal bulb is defective, the control
lamp flashes at double speed.
Automatic dipped beam control
If the light switch is in position
›
›
›
Fig. 131, the side lights, dipped beam
headlights and number plate lights will turn
on or off automatically.
The light is adjusted according to the data re-
corded by the light sensor that is installed
between the windscreen and the inside rear
view mirror.
»
123
Technical dataAdviceOperationEmergenciesSafety
Loading ...
Loading ...
Loading ...