Loading ...
Loading ...
Loading ...
Cleaning and maintenance
66
The seal is not airtight:
• The sealing level selected is unsuitable
for the type of bag used.
Repeat the cycle using a higher sealing
level.
• Too many consecutive sealing cycles.
Wait at least 2 minutes between one
cycle and the next in order to allow the
sealing bar to cool down.
• The bag is larger than the sealing bar.
Use an adequately sized bag.
• The edge of the bag is not positioned
correctly.
Position the edge of the bag at the centre
and make sure that it has no creases. The
bag should protrude 2 cm from the
sealing bar.
• The edge of the bag is dirty.
Before placing the product in the bag,
fold the top over so that the outside
remains clean.
• The sealing bar is dirty.
Clean the sealing bar as described in the
section “Cleaning the sealing bar”.
• The sealing bar or the rubber profile in
the lid are damaged.
Contact the technical assistance service.
• The rubber counter pressure profile of the
sealing bar is not uniform.
Smooth the rubber coating on the
sealing bar.
The indicator light flashes:
• Excessive moisture in the pump.
Run the dehumidification cycle.
Vacuum seal cold foods (3°C) which
have been cleaned, washed and dried
beforehand.
The indicator light turns on and the
appliance emits a beep during the cycle:
• The vacuum has not been started or the
lid has not been closed.
To start the cycle, gently press the glass
lid to start the vacuum.
• Dirt on the seal of the glass lid.
Clean the seal and the internal chamber
with a soft damp cloth and dry
thoroughly.
• Seal of glass lid broken.
Contact the technical assistance service.
• The pump will not start due to the
protective device.
There are 2 buttons in the lower right
section of the appliance for resetting the
protective device.
P re s s t he 2 bu t to n s.
If the fault persists, contact the technical
assistance service.
Loading ...
Loading ...
Loading ...