OWNER’S MANUAL - Page 85

For IBIZA 5D 2015.

Loading ...
Loading ...
Loading ...
Fuses and bulbs
Fuse arrangement in engine compart-
ment
Read the additional information carefully
page 44
Only replace fuses with a fuse of the same
amperage (same colour and markings) and
size.
No. Consumer/Amps
1
Fan, condenser 40
TK8 fan, condenser 50
2 Glow plugs 50
3
ABS Pump 40
EMBOX2-13 (TA8) 20
4 PTC glow phase 2 50
5 PTC glow phase 3 50
6 BDM, 30 ReF 5
7 MSG (KL30) 7.5
8 Windscreen wipers 30
9
Automatic gear box control, AQ 160
Control box
30
10
ABS Ventil 25
EMBOX2-11 (TA8) 5
No. Consumer/Amps
12
Injectors
10
TDI fuel metering adjuster, TA8 ex-
haust temperature sensor
13 Servo sensor 5
14
coolant pump high/low temperature,
gauge (relay EKP)
10
15 50 controls motor diag 5
16 Starter motor 30
17 Controls motor (MSG KL87) 20
18
PTC Relays, TOG sensor, engine
valves, PWM fan
10
19 Interior AUX Fuses 30
20
Glow plug relay, Heizrohr 5
Ignition coil 20
Changing bulbs
Gener
a
l
notes
Read the additional information carefully
page 45
Before changing any bulb, first turn off the
failed device.
Do not touch the glass part of the bulb with
your bare hands. The fingerprints left on the
glass will vaporise as a result of the heat gen-
erated by the bulb, reducing bulb life and
causing condensation on the reflector sur-
face, thus reducing effectiveness.
A bulb must only be replaced by one of the
same type. The type is indicated on the bulb,
either on the glass part or on the base.
Xenon headlights
With this type of headlight, the user can re-
place the turn signal bulb. Replacement of
the dipped/main beam bulb must be done by
Technical Services, given that complex ele-
ments must be removed from the vehicle and
the automatic control system that incorpo-
rates it must be reset.
The Xenon bulbs discharge 2.5 times the
light flux and have an average lifespan of 5
times more than that of halogen bulbs, this
means that, except due to unusual circum-
stances, there is no need to change the bulbs
for the whole life of the vehicle.
WARNING
Take p
articular care when working on com-
ponents in the engine compartment if the en-
gine is warm, there is a risk of burns.
Bulbs are highly sensitive to pressure. The
glass can break when you touch the bulb,
causing injury.
»
83
Technical dataAdviceOperationEmergenciesSafety
Loading ...
Loading ...
Loading ...