Loading ...
Loading ...
Loading ...
Start and driving
Instructions for the driver on the in-
strument panel displ
ay
Press the clutch
●
This message appears on vehicles with a
manual gearbo
x if the driver tries to start the
engine without having the clutch pedal
pressed. The engine will only start if you press
the clutch pedal.
Press the brake
●
This message appears on vehicles with an
automatic gearbox if the driver tries to start
the engine without having the brake pedal
pressed.
Select N or P
●
This message appears if you try to start or
st
op the engine when the selector lever of the
automatic gearbox is not in position P or N.
The engine can only be started and stopped
in those positions.
Engage position P; the vehicle can
move; doors can only close in posi-
tion P.
●
For safety reasons, this driver message ap-
pears and an audible warning sounds if the
selector lever of the automatic gearbox is not
in position P after you switch off the ignition.
Move the selector lever to the P position, oth-
erwise the vehicle could move.
Gear change: selector lever in the
drive position!
●
This driver message is displayed when the
selector lever is not in the position P when the
driver door is opened. Additionally, a buzzing
sound is emitted. Put the selector lever in po-
sition P, otherwise the vehicle could roll away.
Ignition is switched on
●
This driver message is displayed and a buz-
zer is sounded when the driver door is
opened with the ignition switched on.
Driving with electric drive
Switching on the hybrid drive sys-
tem
3 V
alid for: hybrid vehicles
Switching on the hybrid drive activates the
vehicle's propulsion system. When the vehi-
cle’s drive system is switched on, the electric
drive is activated. The combustion engine
starts automatically when the charge level of
the high-voltage battery is not sufficient to
run with the electric drive, or if high drive
power is required.
Requirements for switching on the drive
syst
em
The drive system can be switched on when
the following conditions are met:
●
The high voltage battery has a sufficient
charge level.
●
There is no charging cable plugged in.
●
The temperature of the high-voltage bat-
tery is within the operating range.
●
There is a valid remote control key in the
vehicle.
Switching on the drive system
●
Press the ignition and start button once.
The ignition must be switched on.
●
Press the brake pedal and keep it pressed.
●
Set the gear selector switch to position N or
activate the parking lock P.
●
Press the ignition and start button
›››
Fig. 164 until indicator lamp lights up
on the instrument cluster. Do not press the
accelerator. Release the ignition and start
button when the indicator lamp lights up
on the instrument cluster. The mark on the
power display changes from to .
●
If the indicator lamp does not light up,
cancel and repeat the operation.
●
If the vehicle has been locked with the re-
mote control key, the ignition and start button
is deactivated. If you are inside the vehicle
»
223
Loading ...
Loading ...
Loading ...