Loading ...
Loading ...
Loading ...
GETTING TO KNOW YOUR VEHICLE
60
Before You Begin Programming
HomeLink®
Be sure that your vehicle is parked outside of
the garage before you begin programming.
For more efficient programming and accurate
transmission of the radio-frequency signal it is
recommended that a new battery be placed in
the hand-held transmitter of the device that is
being programmed to the HomeLink® system.
To erase the channels, place the ignition in the
ON position, and push and hold the two
outside HomeLink® buttons (I and III) for up to
20 seconds or until the orange indicator
flashes.
NOTE:
Erasing all channels should only be
performed when programming HomeLink®
for the first time. Do not erase channels
when programming additional buttons.
If you have any problems, or require assis-
tance, please call toll-free 1-800-355-3515
or, on the Internet at
HomeLink.com
for
information or assistance.
Programming A Rolling Code
Garage door openers that were manufactured
after 1995 can be identified by the “LEARN” or
“TRAIN” button located where the hanging
antenna is attached to the garage door
opener.
NOTE:
It is NOT the button that is normally used to
open and close the door. The name and color
of the button may vary by manufacturer.
Training The Garage Door Opener
For programming these garage door openers,
proceed as follows:
1. Place the ignition in the ON/RUN position.
2. Place the hand-held transmitter 1 to 3 inches
(3 to 8 cm) away from the HomeLink® button
you wish to program while keeping the Home-
Link® indicator light in view.
3. Push and hold the HomeLink® button you
want to program while you push and hold
the hand-held transmitter button.
4. Continue to hold both buttons and observe
the indicator light. The HomeLink® indi-
cator will flash slowly and then rapidly after
HomeLink® has received the frequency
signal from the hand-held transmitter.
Release both buttons after the indicator
light changes from slow to rapid.
5. At the garage door opener motor (in the
garage), locate the “LEARN” or “TRAINING”
button. This can usually be found where
the hanging antenna wire is attached to
the garage door opener/device motor.
Firmly push and release the “LEARN” or
“TRAINING” button. On some garage door
openers/devices there may be a light that
blinks when the garage door opener/
device is in the LEARN/TRAIN mode.
NOTE:
You have 30 seconds in which to initiate the
next step after the LEARN button has been
pushed.
6. Return to the vehicle and push the
programmed HomeLink® button twice
(holding the button for two seconds each
time). If the garage door opener/device
activates, programming is complete.
To program the remaining two HomeLink®
buttons, repeat each step for each remain-
ing button. DO NOT erase the channels.
NOTE:
If the garage door opener/device does not
activate, push the button a third time (for two
seconds) to complete the training.
1 — Door Opener
2 — Training Button
20_GA_OM_EN_USC_t.book Page 60
Loading ...
Loading ...
Loading ...