Loading ...
Loading ...
Loading ...
GETTING TO KNOW YOUR VEHICLE
20
To Arm The Alarm
With the doors, hood, and trunk lid closed and
the keyless ignition system placed in the OFF
position, push and release the lock button on
the key fob. The alarm can also be armed by
pushing the Passive Entry door handle button,
located on the exterior door handle. For
further information, refer to "Passive Entry" in
this chapter.
Passive Entry Door Handle Button
When the alarm is armed, the warning lights
on the panels of the interior front door handles
will flash.
Lock/Unlock Buttons
The activation of the alarm is preceded by a
self-diagnosis stage: if a fault is detected, the
system emits a further acoustic signal.
If a second acoustic signal is emitted after the
alarm is already armed, wait about four seconds
and disarm the alarm by pushing the unlock
button. Verify that the doors, hood, and trunk lid
are closed correctly and then rearm the system
by pushing the lock button on the key fob.
If the alarm emits an acoustic signal even when
the doors, hood, and trunk lid are correctly
closed, a fault has occurred in system operation.
In this case, contact an authorized dealer.
To Disarm The Alarm
Push the unlock button to disarm the alarm.
While disarming, the following operations are
performed:
Two brief flashes of the turn signals (if
programmed)
Two brief acoustic signals (if programmed)
Doors are unlocked
The alarm can also be disarmed using the
Passive Entry system, by grasping one of the
Passive Entry front door handles with a valid
key fob in hand to unlock. For further informa-
tion refer to "Passive Entry" in this chapter.
Passive Entry Door Handle Button
NOTE:
The alarm does not disarm when the doors are
unlocked by inserting the blade of the emer-
gency key, found inside the key fob, into the
door handle lock cylinder.
20_GA_OM_EN_USC_t.book Page 20
Loading ...
Loading ...
Loading ...